CID 0545 FMI 06 Ether Start Relay short to ground
Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects excessive current in the circuit.
System Response:
The ECM will log the diagnostic code. The ether relay output from the ECM is disabled.
- Hard starting
Test Step 1. Perform the following diagnostic procedure: Ether Injection System - Test
Results:
- OK - STOP
Caterpillar Information System:
3176C Engines for Caterpillar Built Machines CID 1600 FMI 05 Engine Fan Push Solenoid open circuit
3176C Engines for Caterpillar Built Machines CID 1600 FMI 06 Engine Fan Push Solenoid short to ground
3176C Engines for Caterpillar Built Machines CID 1599 FMI 06 Engine Fan Pull Solenoid short to ground
3176C Engines for Caterpillar Built Machines CID 1599 FMI 05 Engine Fan Pull Solenoid open circuit
Starting and Charging Systems Starter Solenoid Power Circuit (Starter Two) Test Description
Starting and Charging Systems Start Relay (Starter Two) Test Description
3176C Engines for Caterpillar Built Machines CID 0296 FMI 09 Unable to communicate with Transmission ECM
Starting and Charging Systems Starter Solenoid (Starter One) Test Description
657G Wheel Tractor-Scraper Wheel Tractor Power Train Drive Shaft - Disassemble
3508B, 3512B, and 3516B High Displacement Generator Sets Air Shutoff - Test - Engines That Are Equipped with ADEM II or ADEM III Engine Control Modules
D7G Series 2 and D7G Series II Track-Type Tractors Leaving the Machine
3176C Engines for Caterpillar Built Machines Digital Sensor Supply Circuit - Test
2006/07/03 A New Implement Pump Is Now Used {5073}
3176C Engines for Caterpillar Built Machines CID 0545 FMI 05 Ether Start Relay open/short to +batt
D7G Series 2 and D7G Series II Track-Type Tractors Sound Information and Vibration Information
657G Wheel Tractor-Scraper Machine Systems Relay Valve (Brake) - Remove and Install
D7G Series 2 and D7G Series II Track-Type Tractors Plate Locations and Film Locations
657G Wheel Scraper Power Train Transfer Gears - Disassemble
657G Wheel Scraper Power Train Transfer Gears - Assemble
D3K, D4K and D5K Track-Type Tractors Electrohydraulic System Hydraulic Oil Contamination - Test
657G Wheel Tractor-Scraper Hydraulic System Oil - Change
953D Track-Type Loader Power Train Piston Pump (Hydrostatic) - Install - Left Side
D3K, D4K and D5K Track-Type Tractors Electrohydraulic System Lift Cylinder Drift (Bulldozer) - Check
D5R Track-Type Tractor Machine Systems Drawbar