854K Wheel Dozer Caterpillar


Hydraulic System Oil Filter (Steering Pilot) - Replace

Usage:

854K 221


注意

在检查、保养、测试、调整及维修产品时,请小心确保盛接油液。 在打开任何舱室或拆卸任何含有油液的部件前,请准备好盛接液体用的适当容器。


  1. 停止发动机。


    图 1g01278534

  2. 液压油滤清器位于泵室的左侧。 打开检修门。


    图 2g01278787

  3. 拆下滤清器并正确废弃滤清器。

  4. 在新滤清器密封件上涂上一薄层油。 安装新滤清器,用手拧紧到滤清器的密封与底座接触为止。 记住滤清器上分度标记相对于基座上固定标记的相对位置。

    注: 在滤清器上有相互间隔 90 度或 1/4圈 的旋转指示记号。 当你拧紧滤清器时应利用旋转指示记号作为指引。

  5. 根据滤清器上的说明来拧紧滤清器。 将指示标记作为指导。 对于非 Caterpillar 滤清器,按照滤清器的使用说明来安装。

    注: 安装时可能需要用到 Caterpillar 带式扳手或其它适当的工具来拧紧滤清器,直至达到最终安装要求的转动量。 要确保安装工具不会损坏滤清器。

  6. 关闭检修门。

Caterpillar Information System:

D7G Series 2 and D7G Series II Track-Type Tractors Engine Starting with Auxiliary Start Receptacle
D6G Series 2 Track-Type Tractor Power Train Visual Inspection
D7G2 Track-Type Tractor Power Train Machine Preparation
D7G Series 2 and D7G Series II Track-Type Tractors Engine and Machine Warm-Up
Installation of a 3406 Engine Emissions Upgrade Group Retrofit for 980F and 980F Series II Wheel Loader (Single HP and Dual HP){1000, 1000} Installation of a 3406 Engine Emissions Upgrade Group Retrofit for 980F and 980F Series II Wheel Loader (Single HP and Dual HP){1000, 1000}
Bench Test Procedure For A 589 Pipelayer, D8L, D9L, D9N, And D10N Track-Type Tractor Torque Converter{3101} Bench Test Procedure For A 589 Pipelayer, D8L, D9L, D9N, And D10N Track-Type Tractor Torque Converter{3101}
C4.4 Industrial Engine Turbocharger - Inspect
854K Wheel Dozer Hydraulic System Oil Filter (Implement Pilot) - Replace
657G Wheel Tractor-Scraper Engine Supplement Radiator Module - Install
657G Wheel Tractor-Scraper Engine Supplement Radiator Module - Remove
854K Wheel Dozer Steering Cylinder Bearings - Lubricate
Guidelines for Effective Track Frame Guarding to Reduce Packing and Sprocket Indexing{4150} Guidelines for Effective Track Frame Guarding to Reduce Packing and Sprocket Indexing{4150}
D7G2 Track-Type Tractor Power Train Track Tension - Test and Adjust
988H, 988K, 990H, 990K, 992G, 992K, 993K, and 994K Wheel Loaders, and 854K Wheel Dozers Automatic Lubrication System (Hydraulic Actuated System) Electrical System
3176C Engines for Caterpillar Built Machines Engine Speed/Timing Sensor Circuit - Test
C11 and C13 Engines Muffler
D6G Series 2 Track-Type Tractor Window Washer Reservoir - Fill
D6G Series 2 Track-Type Tractor Battery Disconnect Switch
C4.4 Industrial Engine Engine Valve Lash - Inspect/Adjust
Inlet Air Heater Failure on Wheel Loaders, Track-Type Loaders, and Track-Type Tractors{1090} Inlet Air Heater Failure on Wheel Loaders, Track-Type Loaders, and Track-Type Tractors{1090}
657G Wheel Tractor-Scraper Engine Supplement Coolant Tank - Remove and Install
Improving the Cab Environment for the Operator of Track-Type Tractors{7301, 7304, 7320} Improving the Cab Environment for the Operator of Track-Type Tractors{7301, 7304, 7320}
D6G Series 2 Track-Type Tractor Fuses and Circuit Breakers - Replace/Reset
Installing the Updated Hoses For the Tilt Lines and the Implement Pump{5057, 5084} Installing the Updated Hoses For the Tilt Lines and the Implement Pump{5057, 5084}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.