Crankcase Breather
Show/hide table
图 1 | g01157144 |
(1) 夹子
- 扭矩 ... 4 ± 0.5 N·m (35.5 ± 5 lb in)
(2) 夹子
- 扭矩 ... 7 ± 1.5 N·m (62 ± 13 lb in)
(3) O 形密封圈
在孔中涂抹清洁的发动机机油。
Caterpillar Information System:
G3400 Engines (EIS) Diagnostic Codes
2006/01/16 40 Power Microscope is Available for Inspecting Bearing Journals on Crankshafts {0777, 1202}
C13 and C15 On-highway Engines Engine Misfires, Runs Rough or Is Unstable
Procedure for Filtering 9U-5000 Hydraulic Test Bench Hydraulic Oil {0680, 0738, 0768, 0784, 5050, 5056} Procedure for Filtering 9U-5000 Hydraulic Test Bench Hydraulic Oil {0680, 0738, 0768, 0784, 5050, 5056}
3500 Generator Sets Starting the Engine
C13 and C15 On-highway Engines Engine Cranks but Does Not Start
3406E and C15 Marine Engines Safety Messages
C13 and C15 On-highway Engines Cooling Fan Is Always ON
G3400 Engines (EIS) Short Spark Plug Life
G3400 Engines (EIS) Poor Fuel Consumption
G3400 Engines (EIS) Mechanical Noise (Knock) in Engine
G3400 Engines (EIS) Low Power/Poor or No Response to Throttle
3500 Generator Sets Fuel System Primary Filter/Water Separator - Drain
C9 Engines for Caterpillar Built Machines Fan Drive - Install
C9 Engines for Caterpillar Built Machines Fan Drive - Disassemble
G3400 Engines (EIS) Control Module Self Test
3606 and 3608 Engines Cylinder Block
C9 Engines for Caterpillar Built Machines Fan Drive - Assemble
3618 Engine Refill Capacities and Recommendations
C27 and C32 Engines Air Inlet and Exhaust System - Inspect
G3400 Engines (EIS) Electrical Power Supply
C4.4 Marine Generator Set Engines Fuel Priming Pump and Fuel Filter Base - Remove and Install
TH48-E80 Petroleum Transmission Lubricant Viscosities
C27 and C32 Engines Cooling System - Check - Overheating