Make sure that all of the warning signs are legible. Clean the warning signs or replace the warning signs if you cannot read the words. Replace the illustrations if the illustrations are not visible. When you clean the warning signs, use a cloth, water and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the warning signs. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the warning sign. Loose adhesive will allow the warning sign to fall.
Replace any warning sign that is damaged, or missing. If a warning sign is attached to a part that is replaced, install a warning sign on the replacement part. Any Caterpillar dealer can provide new warning signs.
Do Not Operate
 | |
| Illustration 1 | g00295730 |
The warning sign is located in the operator station. | |
 | |
| Illustration 2 | g00038370 |
 |
DO NOT OPERATE OR WORK ON THIS MACHINE UNLESS YOU HAVE READ AND UNDERSTAND THE INSTRUCTIONS AND WARNINGS IN THE OPERATION AND MAINTENANCE MANUALS. FAILURE TO FOLLOW THE INSTRUCTIONS OR HEED THE WARNINGS COULD RESULT IN INJURY OR DEATH. CONTACT ANY CATERPILLAR DEALER FOR REPLACEMENT MANUALS. PROPER CARE IS YOUR RESPONSIBILITY. |
 |
Do Not Weld On The ROPS Or On The FOPS (If Equipped)
 | |
| Illustration 3 | g00100263 |
The warning sign is located on the vertical support of the ROPS or of the FOPS (if equipped). | |
 | |
| Illustration 4 | g00100265 |
|
Structural damage, an overturn, modification, alteration, or improper repair, can impair this structure's protective capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification. |
|
Improper Connections Of The Jump Start Cable
 | |
| Illustration 5 | g00295732 |
The warning tag is located in the battery compartment behind the radiator guard. | |
 | |
| Illustration 6 | g00038786 |
|
Improper jumper cable connections can cause an explosion resulting in personal injury. |
|
High Pressure Cylinder
 | |
| Illustration 7 | g00295733 |
The warning tag is located on both of the track roller frames. | |
|
High Pressure Cylinder. Do not remove any parts until all pressure has been relieved to avoid possible personal injury. Relieve pressure by opening relief valve one turn maximum. See the Operation and Maintenance Manual for correct procedure. |
|