Engine Crankcase Breather - Clean
Show/hide table
NOTICE |
---|
Perform this maintenance with the engine stopped. |
If the crankcase breather is not maintained on a regular basis, the crankcase breather will become plugged. A plugged crankcase breather will cause excessive crankcase pressure that may cause crankshaft seal leakage.
Show/hide table
Illustration 1 | g01013323 |
Typical example (1) Hose clamp (2) Retaining bolt and washer (3) Breather assembly |
- Loosen hose clamp (1) and remove the hose from breather assembly (3) .
- Remove bolt (2) and the washer. Remove the breather assembly and the seal.
- Wash the breather element in solvent that is clean and nonflammable. Allow the breather element to dry before installation.
- Install a breather element that is clean and dry. Install the breather assembly and the seal. Install the bolt and the washer. Refer to Specifications Manual, SENR3130 in order to locate the proper torques.
- Install the hose. Install the hose clamp. Refer to Specifications Manual, SENR3130 in order to locate the proper torques.
Caterpillar Information System:
2003/08/01 A Previous High Temperature Locknut is Used in Engine Exhaust System Groups {7553}
G3406 Engines Ignition Transformer
SPP101 Skid Mounted Pumper Model View Illustrations
C3.3 Industrial Engine Cylinder Block - Inspect
3500B and 3500C Marine Engines Engine Governing - Adjust
G3520B Engines Engine Overcrank
SPP101 Skid Mounted Pumper Maintenance Interval Schedule
G3406 Engines Water Temperature Regulator
2003/10/01 An Improved Alternator Belt is Used {1357}
C11, C13 and C15 On-highway Engines Maintenance Parameters
C4.4 Industrial Engine Increased Engine Oil Temperature - Inspect
C11 and C13 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Assemble
C11 and C13 Engines for Caterpillar Built Machines Crankshaft - Remove
C15 On-highway Engine Inlet and Exhaust Valve Seat Inserts - Remove and Install
C15 On-highway Engine Inlet and Exhaust Valves - Remove and Install
C15 On-highway Engine Inlet and Exhaust Valve Guides - Remove and Install
C11 and C13 Engines Crankshaft - Install
C11 and C13 Engines Engine Oil Cooler - Remove
C11 and C13 Engines Diverter Valve (Coolant) - Remove
2003/12/01 SOLAS Requirements for Fuel Lines {1274}
3126E and 3126B Commercial and Truck Engines Engine Oil and Filter - Change
C15 and C18 Generator Set Engines Cylinder Liner - Install
C15 and C18 Generator Set Engines Cylinder Liner - Remove
C15 On-highway Engine Inlet and Exhaust Valve Springs - Remove and Install