5.4" BORE, 60 V12 VEHICULAR ENGINE Caterpillar

(1) Width of groove for ring in thrower ... .2515 ± .0005 in.(6.388 ± 0.013 mm)

Maximum permissible runout (axial eccentricity) of face of ring groove ... .002 in.(0.05 mm)

Clearance between ring and side of groove ... .0025 to .0045 in.(0.064 to 0.114 mm)

Put crankcase oil on ring and install ring word "OUT" away from crankshaft.

NOTE: Do not heat wear sleeves (A) to more than 300°F (149°C) before installation on the crankshaft.

(2) Before installation do not heat thrower or gear higher than maximum temperature of ... 300°F (149°C)

(3) End play for crankshaft ... .010 to .025 in.(0.25 to 0.64 mm)

NOTE: Make reference to Special Instruction SEHS6713 for procedures for crankshaft reconditioning.