Engine/Generator Setpoint Viewing OP2
OP2 is the option for viewing the setpoints of the generator set. The engine setpoints and the generator setpoints affect the operation and serviceability of the engine. The setpoints affect the accuracy of the information that is shown on the display. The setpoints that are viewed on the GSC should match the specified setpoints of the control panel. The programmable setpoints that are covered under OP2 are P01 through P24. See Systems Operation, "Setpoint Programming OP5" for a description of each of these setpoints.
Procedure To View The Setpoints
- Press the "SERVICE MODE" key in order to enter service mode. "OP 1" is showing on the lower display. See Systems Operation, "Service Mode"for more information.
- Press "SCROLL UP" key. "OP 2" is showing.
- Press "SELECT" key. "P01" is followed by the value of the setpoint that is showing.
- Press "SCROLL UP" or "SCROLL DOWN" key. The next setpoint is showing with the corresponding value. Repeat this step until all the desired setpoints and corresponding values are viewed.
- Press "EXIT" key. "OP 1" is showing on lower display.
- Press "EXIT" key. The display returns to the normal mode.
Caterpillar Information System:
Electronic Modular Control Panel II (EMCP II) For MUI Engines Fault Log Viewing OP1
Electronic Modular Control Panel II (EMCP II) For MUI Engines Service Mode
Electronic Modular Control Panel II (EMCP II) For MUI Engines Shutdown Mode
Electronic Modular Control Panel II (EMCP II) For MUI Engines Alarm Mode
G3606 and G3608 Engines Engine Design
P16, P20, P25, P28, P40 and P60 Pulverizer Crusher Tooth and Cutting Edge Bolts - Tighten
Electronic Modular Control Panel II (EMCP II) for EUI Engines Normal Mode
Electronic Modular Control Panel II (EMCP II) for EUI Engines Modes Of Operation
Electronic Modular Control Panel II (EMCP II) for EUI Engines Electronic Control Module (Engine)
Electronic Modular Control Panel II (EMCP II) for EUI Engines Sensors
Electronic Modular Control Panel II (EMCP II) for EUI Engines Electrical Converter (Pulse Width Modulated)
C-10 and C-12 Truck Engines Electronic Control System
G3520C and G3520E Engines Flywheel Housing Cover
Electronic Modular Control Panel II (EMCP II) For MUI Engines Password Entry OP3
Electronic Modular Control Panel II (EMCP II) For MUI Engines Fault Log Clearing OP4
Electronic Modular Control Panel II (EMCP II) for EUI Engines Engine/Generator Programming OP5
Electronic Modular Control Panel II (EMCP II) for EUI Engines Spare Input/Output Programming OP6
Electronic Modular Control Panel II (EMCP II) for EUI Engines Hourmeter Programming OP7
G3606 and G3608 Engines Engine Supervisory System
Electronic Modular Control Panel II (EMCP II) For MUI Engines Voltmeter/Ammeter Programming OP8
Electronic Modular Control Panel II (EMCP II) for EUI Engines Engine Setpoint Verification OP9
Electronic Modular Control Panel II (EMCP II) for EUI Engines AC Offset Adjustment OP10
Electronic Modular Control Panel II (EMCP II) for EUI Engines Fault Description
Electronic Modular Control Panel II (EMCP II) for EUI Engines AL Fault Codes