Start By:
- Remove the front wheel. Refer to Disassembly and Assembly, "Wheel (Front Wheel Assist) - Remove and Install".
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide"for tools and supplies to collect and contain fluids in Caterpillar machines. Dispose of all fluids according to local regulations. |
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes.
- Drain the hydraulic oil from the hydraulic oil tank into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual for the correct procedure.
Show/hide table
Illustration 1 g02108766 - Disconnect three hose assemblies (2) from piston motor (3).
- Disconnect hose assembly (1).
Note: Disconnect hose assembly (1) from piston motor (3) after piston motor (3) has been removed from the machine.
Show/hide tableIllustration 2 g02108767 - Remove two bolts (4) from piston motor (3).
- Attach a suitable lifting device to piston motor (3). Remove eight bolts (5), hose assembly (1), and piston motor (3) from the machine. The weight of piston motor (3) is approximately
39 kg (86 lb) . - Remove hose assembly (1) from piston motor (3).
- Install piston motor (3) in the reverse order of removal.
End By:
- Install the front wheel. Refer to Disassembly and Assembly, "Wheel (Front Wheel Assist) - Remove and Install".