Piston Pump - Remove
Removal Procedure
Start By:
- Release the system pressure
- Remove the floorplate.
Show/hide table
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
- Drain the hydraulic oil into a suitable container.
- Loosen clamp (1) and disconnect hose (2) .
Show/hide table
Illustration 1 | g03693899 |
- Disconnect hose assemblies (3) and (4) .
- Remove four bolts (5) and hose assembly (6) .
Show/hide table
Illustration 2 | g03693902 |
- Attach a suitable lifting device to piston pump (8). The weight of piston pump (8) is approximately 29 kg (64 lb). Remove bolts (7). Lower piston pump (8) out of the machine.
Show/hide table
Illustration 3 | g03686544 |
Note: Typical example
Show/hide table
Illustration 4 | g03693904 |
Caterpillar Information System:
424B Backhoe Loader Machine Systems Bank Valve (Loader) - Install
794 AC Off-Highway Truck Machine Systems Cab Mounting
834H Wheel Dozer and 836H Landfill Compactor Maintenance Interval Schedule
3516B Generator Set Engines with Dynamic Gas Blending Engine Has Early Wear
794 AC Off-Highway Truck Machine Systems Axle Mounting
416F2, 420F2 and 430F2 Backhoe Loaders Safety Messages
966M XE and 972M XE Wheel Loaders Power Train, Steering, Braking, Hydraulic, and Machine Systems Piston Pump (Steering) - Mounting
794 AC Off-Highway Truck Machine Systems Control Manifold (Steering)
424B Backhoe Loader Machine Systems Bank Valve (Loader) - Remove
794 AC Off-Highway Truck Machine Systems Battery
794 AC Off-Highway Truck Machine Systems Piston Pump
794 AC Off-Highway Truck Machine Systems Electronic Control Module
966M XE and 972M XE Wheel Loaders Power Train, Steering, Braking, Hydraulic, and Machine Systems Hydraulic Pump and Mounting
422F2, 426F2, 428F2, 432F2, 434F2 and 444F2 Backhoe Loaders Engine Oil and Filter - Change
422F2, 426F2, 428F2, 432F2, 434F2 and 444F2 Backhoe Loaders Fuel Tank Water and Sediment - Drain
416F2, 420F2 and 430F2 Backhoe Loaders Hydraulic Oil Sample - Obtain
C1.5 and C2.2 Engines for Caterpillar Built Machines Sensor Signal (Analog, Passive) - Test
725C2 and 730C2 Articulated Truck Machine System Cab - Remove and Install
424B Backhoe Loader Machine Systems Piston Pump - Install
C3.4B Industrial Engine Diesel Exhaust Fluid - Fill
794 AC Off-Highway Truck Machine Systems Hoist Cylinder and Mounting
140H, 143H, 160H and 163H Motor Graders Power Train Electronic Control System Data Link
826K Landfill Compactor, 825K Soil Compactor and 824K Wheel Dozer Power Train Differential and Bevel Gear - Remove and Install - Rear Axle
140H, 143H, 160H and 163H Motor Graders Power Train Electronic Control System Using Caterpillar Electronic Technician to Determine Diagnostic Codes