Flywheel Housing Runout
Usage:
Face Runout (Axial Eccentricity) Of The Flywheel Housing:
8T5096 Dial Indicator Group Installed
1. Fasten a dial indicator to the crankshaft flange so the anvil of the indicator will touch the face of the flywheel housing.
2. Put a force on the crankshaft toward the rear before reading the indicator at each point.
3. With dial indicator set at 0.00 mm (.000 in) at location (A), turn the crankshaft and read the indicator at locations (B), (C) and (D).
4. The difference between lower and higher measurements taken at all four points must not be more than 0.25 mm (.010 in), which is the maximum permissible face run out (axial eccentricity) of the flywheel housing.
Caterpillar Information System:
3208 INDUSTRIAL ENGINE Flywheel Runout
3208 INDUSTRIAL ENGINE Flywheel Housing
3208 INDUSTRIAL ENGINE Bearings For Connecting Rods And Mains
3208 INDUSTRIAL ENGINE Crankshaft
3208 INDUSTRIAL ENGINE Crankshaft Seals
3208 INDUSTRIAL ENGINE Pistons And Rings
3208 INDUSTRIAL ENGINE Connecting Rod
3208 INDUSTRIAL ENGINE Cylinder Block
3208 INDUSTRIAL ENGINE Belt Tension Chart
3208 INDUSTRIAL ENGINE Water Temperature Regulator
3208 INDUSTRIAL ENGINE Water Pump
3208 INDUSTRIAL ENGINE Oil Level Gauge
3208 INDUSTRIAL ENGINE Flywheel Housing Bore
3208 INDUSTRIAL ENGINE Pulley And Damper Group
3208 INDUSTRIAL ENGINE Flywheel
3208 INDUSTRIAL ENGINE Alternators and Regulators
3208 INDUSTRIAL ENGINE Electric Starter Motor
3208 INDUSTRIAL ENGINE Systems Operation
3208 INDUSTRIAL ENGINE Testing & adjusting
3208 INDUSTRIAL ENGINE Introduction
3208 INDUSTRIAL ENGINE Air Inlet Manifold
3208 INDUSTRIAL ENGINE Aftercooler
3208 INDUSTRIAL ENGINE Oil Level Gauge
3208 INDUSTRIAL ENGINE Engine Lifting Brackets