Engine Oil Pump - Disassemble
Disassembly Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 5F-7344     | Puller Block     | 1     |
7S-7786 | Puller Leg     | 1     | |
5F-7345 | Screw     | 1     |
Start By:
- Remove the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Remove ".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolts (1) and cover (2) .
Show/hide table
Illustration 1 | g01178186 |
- Remove O-ring seal (4) and idler gear (7) from housing (5) .
- Use Tooling (A) to remove gear (6) from drive shaft (3) .
- Remove drive shaft (3) from the housing.
Show/hide table
NOTICE |
---|
Before removing the drive shaft from the pump housing, be sure that no burrs exist on the drive shaft. If the drive shaft has burrs on it, the bores in the pump housing may be scratched. |
Caterpillar Information System:
C6.6 Industrial Engine Introduction
C3.3 and C4.4 Rental Generator Sets Stopping the Engine
C280 Marine and Petroleum Engines Engine Speed/Timing Sensor
C-10 Petroleum Engine Engine Oil Pump - Remove
C9 Engine for Caterpillar Built Machines Cylinder Head - Install
C15 and C18 Engines for Caterpillar Built Machines Gear Group (Front)
C15 and C18 Engines for Caterpillar Built Machines Valve Rocker Arm
C2.2 Generator Sets Starting the Engine
C15 and C18 Engines for Caterpillar Built Machines Electronic Unit Injector Rocker Arm
2006/02/06 A New Exhaust Manifold Gasket is Used {1059}
C15 On-Highway Engine Electronic Unit Injector
C9 Engine for Caterpillar Built Machines Cylinder Head - Remove
Filtration Procedure for Hydraulic Oil in Compact Equipment {0680, 0768, 5050, 5056} Filtration Procedure for Hydraulic Oil in Compact Equipment {0680, 0768, 5050, 5056}
C-10 Petroleum Engine Engine Oil Pump - Assemble
C-10 Petroleum Engine Engine Oil Pump - Install
C18 Marine Engines Engine Oil Level Gauge - Calibrate
C13 On-highway Engine Water Pump
C13 Engine for Combat and Tactical Vehicles Atmospheric Pressure Sensor
C-10 Petroleum Engine Flywheel - Remove
C-10 Petroleum Engine Flywheel - Install
C9.3 Tier 4 Final Engines Engine Oil Pressure Sensor
C-10 Petroleum Engine Crankshaft Rear Seal - Remove
C27 and C32 Engines for Caterpillar Built Machines Coolant Temperature Sensor
C2.2 Generator Sets Refill Capacities and Recommendations