Usage:
Remove Fuel Transfer Pump
1. Remove line (1). Disconnect line (5). Remove bolts (4) that hold service meter to the fuel transfer pump. Remove service meter. Remove bolts (3) that hold fuel transfer pump (2) to accessory drive shaft housing. Remove fuel transfer pump (2).
Install Fuel Transfer Pump
1. Install service meter and bolts on the fuel transfer pump. Put fuel transfer pump in position on the accessory drive shaft housing and install the bolts that hold it.
2. Connect fuel priming pump and fuel transfer pump lines.
Disassemble Fuel Transfer Pump
start by:
a) remove fuel transfer pump
1. Remove nut (2), gear (3) and key.
2. Remove the cage (1).
3. Remove the O-ring seals from the cage.
4. Remove the bearing and seals from the cage with tooling (A).
5. Remove the cover (5).
NOTICE |
---|
Be careful not to cause damage to surfaces of cover and pump body that fit together. |
6. Remove the seal from the cover.
7. Remove the gear (4) and the gear and shaft (6) from pump body.
8. Remove the bearing from the pump body with tooling (A).
Assemble Fuel Transfer Pump
1. Clean all parts before assembling pump.
2. Install the bearing in pump body with driver (1) from tool group (A).
3. Install seal in cover (2) with tooling (B). The seal must be installed .450 in. (11.430 mm) in from the outer surface.
4. Put the gear and shaft in position in the body.
5. Put a small amount of 8S6747 Permatex Aviation Type form a gasket on the surface of the pump body.
NOTICE |
---|
Do not let Permatex enter the pump. |
6. Install cover on pump body.
NOTE: After tightening bolts in the cover the gear and shaft must turn freely.
7. Install bearing in cage with the driver from tool group (A).
8. Install the seals (4) in the cage with tool (B). Seal (3) must be .580 in. (14.732 mm) in from the surface and lip of seal must be toward the bushing end of the cage. Seal (5) must be .120 in. (3.048 mm) in from the surface and lip of seal must be toward the pump gears.
9. Install the O-ring seals on the cage.
10. Put clean SAE 30 engine oil on seals.
11. Install seal installer (6) from tool group (A) on the shaft.
12. Install the cage over the seal installer and on to the shaft.
13. Remove the seal installer and install key, gear and nut. Tighten nut to a torque of 22 ± 5 lb.ft. (3.0 ± 0.7 mkg).
end by:
a) install fuel transfer pump