Usage:
start by:
a) remove fuel injector pump housing and governor
NOTICE |
---|
Before any service work is done on the fuel system, the outer surface of the injection pump housing must be clean. |
1. Remove fuel lines (3). Remove two bolts (2) and remove flange and flange assembly (1).
2. Remove check valve (4) from the flange assembly.
3. Remove seven bolts (6) that hold cover (5) to the pump housing.
4. Remove cover (5) from the pump housing.
5. Remove spring (7) and the bypass valve from the pump housing.
Install Check Valve And Bypass Valve
1. Install bypass valve (2) and spring (1) in the pump housing.
2. Install cover (3) on the pump housing. Be sure spring (1) is in the bore in the lever.
3. Install the seven bolts that hold the cover to the pump housing.
4. Install a new gasket (5) on the cover. Install a new check valve (4) in flange assembly (6). Put the flange assembly in position on the cover.
5. Install a new gasket (7) on the flange assembly. Install flange (8) on the flange assembly with the bolts that hold them to the cover.
end by:
a) install fuel injection pump housing and governor