Flywheel Housing Runout
Usage:
8S2328 DIAL INDICATOR GROUP INSTALLED
Face Runout (axial eccentricity) of the Flywheel Housing:
1. Fasten a dial indicator to the crankshaft flange so the anvil of the indicator will touch the face of the flywheel housing.
2. Put a force on the crankshaft toward the rear before reading the indicator at each point.
3. With dial indicator set at .000 in. (0.00 mm) at location (A), turn the crankshaft and read the indicator at locations (B), (C) and (D).
4. The difference between lower and higher measurements taken at all four points must not be more than .012 in. (0.30 mm), which is the maximum permissible face run out (axial eccentricity) of the flywheel housing.
Caterpillar Information System:
3406 DIESEL TRUCK ENGINE Flywheel Housing Bore
3406 DIESEL TRUCK ENGINE Flywheel Housings
3406 DIESEL TRUCK ENGINE Pistons And Rings
3406 DIESEL TRUCK ENGINE Connecting Rod
3406 DIESEL TRUCK ENGINE Connecting Rod And Main Bearing Journals
3406 DIESEL TRUCK ENGINE Crankshaft
3406 DIESEL TRUCK ENGINE Cylinder Liner Projection
3406 DIESEL TRUCK ENGINE Cylinder Liner
3406 DIESEL TRUCK ENGINE Cylinder Block
3406 DIESEL TRUCK ENGINE Water Pump
3406 DIESEL TRUCK ENGINE V-Belt Tension Chart
3406 DIESEL TRUCK ENGINE Water Temperature Regulator
3406 DIESEL TRUCK ENGINE Flywheels
3406 DIESEL TRUCK ENGINE Flywheel Runout
3406 DIESEL TRUCK ENGINE BrakeSaver
3406 DIESEL TRUCK ENGINE Brakesaver Control Valve (9N29)
3406 DIESEL TRUCK ENGINE Timing Gear Housing
3406 DIESEL TRUCK ENGINE Tachometer Drive
3406 DIESEL TRUCK ENGINE Air Compressor Drive
3406 DIESEL TRUCK ENGINE Connections For Glow Plug Wiring
3406 DIESEL TRUCK ENGINE Starter Motors (Delco-Remy)
3406 DIESEL TRUCK ENGINE Starter Solenoids
3406 DIESEL TRUCK ENGINE Shut-Off Solenoids (12V)
3406 DIESEL TRUCK ENGINE Alternator