Water Directors
Usage:
Remove And Install Water Directors
start by:
a) remove cylinder head assembly
1. Remove water director (1) from cylinder head.
2. Install new water director with tooling (A).
Show/hide table
NOTICE |
---|
Hole (2) in water director must be in alignment with "V" mark on cylinder head. |
end by:
a) install cylinder head assembly.
Caterpillar Information System:
D353 INDUSTRIAL & MARINE ENGINES Valve Guides
D353 INDUSTRIAL & MARINE ENGINES Valve Seat Inserts
D353 INDUSTRIAL & MARINE ENGINES Valves
D353 INDUSTRIAL & MARINE ENGINES Valve Lifters
D353 INDUSTRIAL & MARINE ENGINES Spacer Plate
D353 INDUSTRIAL & MARINE ENGINES Cylinder Head Assembly (Later)
D353 INDUSTRIAL & MARINE ENGINES Cylinder Head Assembly (Earlier)
D353 INDUSTRIAL & MARINE ENGINES Rocker Shaft Assembly
D353 INDUSTRIAL & MARINE ENGINES Rocker Shaft Assembly And Push Rods
D353 INDUSTRIAL & MARINE ENGINES Intake Manifold
D353 INDUSTRIAL & MARINE ENGINES Aftercooler
D353 INDUSTRIAL & MARINE ENGINES Water Manifold
D353 INDUSTRIAL & MARINE ENGINES Camshaft
D353 INDUSTRIAL & MARINE ENGINES Camshaft Bearings
D353 INDUSTRIAL & MARINE ENGINES Pistons (Earlier)
D353 INDUSTRIAL & MARINE ENGINES Pistons (Later)
D353 INDUSTRIAL & MARINE ENGINES Pistons
D353 INDUSTRIAL & MARINE ENGINES Cylinders Liners (Earlier)
D353 INDUSTRIAL & MARINE ENGINES Cylinder Liners (Later)
D353 INDUSTRIAL & MARINE ENGINES Vibration Damper And Pulley
D353 INDUSTRIAL & MARINE ENGINES Front Cover
D353 INDUSTRIAL & MARINE ENGINES Crankshaft Front Seal
D353 INDUSTRIAL & MARINE ENGINES Flywheel
D353 INDUSTRIAL & MARINE ENGINES Crankshaft Rear Seal