Coolant Temperature Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Drain the coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change" for the correct draining and filling procedures.
Show/hide table
Illustration 1 g03859406 - Disconnect harness assembly (2).
- Remove coolant temperature sensor (1).
- Install coolant temperature sensor (1) in the reverse order of removal.
- Lubricate the bore of coolant temperature sensor (1) with the fluid that is being sealed.
- Tighten coolant temperature sensor (1) to a torque of
20 ± 3 N·m (177 ± 27 lb in) .
Caterpillar Information System:
C280 Marine Engines Fuel Pressure
3512C Generator Set Engine Turbocharger Outlet Pressure Sensor - Remove and Install
120 and 120 AWD Motor Grader Fuel System Water Separator - Drain
3512C Generator Set Engine Turbocharger Inlet Pressure Sensor - Remove and Install
120 and 120 AWD Motor Grader Fuel System Filter - Replace
CX31-P600 Petroleum Transmission Maintenance Interval Schedule
3512C Generator Set Engine Engine Oil Pressure Sensor - Remove and Install
3512C Generator Set Engine Coolant Level Sensor - Remove and Install
120 and 120 AWD Motor Grader Engine Oil Sample - Obtain
745 and 740 GC & 740 EJECTOR Articulated Truck Systems Solenoid Valve
349F and 352F Excavators Machine System Specifications Gear Pump
HPU300 Hydraulic Power Pack Additional Messages
CG137-08 and CG137-12 Engines Engine Air Cleaner Service Indicator - Inspect - If Equipped
3512C Generator Set Engine Aftercooler Coolant Temperature Sensor - Remove and Install
794 AC Off-Highway Truck Field Assembly Mirror - Install
C280-08 Tier 4 Engine Turbocharger - Disassemble
3512C Generator Set Engine Engine Speed/Timing Sensor - Remove and Install
Fundamentals of Plasma Transferred Wire Arc (PTWA) Spray for Reconditioning Components {0374, 0599, 0679, 1000} Fundamentals of Plasma Transferred Wire Arc (PTWA) Spray for Reconditioning Components {0374, 0599, 0679, 1000}
C8.7 Marine Engine Crankshaft Pulley - Remove and Install
2015/09/04 A New Breather Hose Is Now Used on Certain 3512 Engines {1317}
XQ400 Power Module Safety Messages
3512C Generator Set Engine Crankcase Pressure Sensor - Remove and Install
3512C Generator Set Engine Atmospheric Pressure Sensor - Remove and Install
C8.7 Marine Engine Crankshaft Gear - Remove and Install