Turbocharger
Show/hide table
| |
| Illustration 1 | g01424863 |
|
Typical example | |
(1) Torque for the compressor clamp assembly ...
Use the following procedure to tighten the turbine clamp assembly (2):
- Tighten the turbine clamp assembly to
18.1 N·m (160.2 lb in) . - Loosen the turbine clamp assembly to
5.6 N·m (49.6 lb in) . - Again, tighten the turbine clamp assembly to
13.5 ± 1.0 N·m (119.5 ± 8.9 lb in) .
Wastegate setting ...
Caterpillar Information System:
C13, C15, and C18 Tier 4 Final Engines Turbocharger
C7.1 Industrial Engine and Generator Set Analog Throttle Position Sensor Circuit - Test
C7.1 Industrial Engine and Generator Set No Diagnostic Codes Detected
789D, 793F, and 797F Off-Highway Truck Monitoring System Connector Contact Description
2009/05/04 A Repair Kit for the Magnet is Now Available for the AccuGrade CD700 Display {7490}
C13 Tier 4 Final Engines Lubrication System
C18 Marine Generator Set Configuration Parameters
793F and 797F Off-Highway Trucks Chassis Electronic Control System MID 087 - CID 0800 - FMI 09
PM3516 Power Modules Fumes Disposal Filter - Drain
C15 and C18 Industrial Engines Flame Detection Temperature Sensor - Remove and Install - Clean Emissions Module
2009/04/20 How Is Service Information Accessed / Used {0374, 1000, 7000}
2009/04/27 An Improved Rod for the Recoil Spring is Now Used {4158}
C9.3 Engines for Caterpillar Built Machines Electrical Connectors - Inspect
3412C Generator Set Generator Bearing Temperature - Measure/Record
C27 and C32 Engines for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install - C32
C9.3 Engines for Caterpillar Built Machines ECM Software - Install
793F and 797F Off-Highway Trucks Braking System MID 116 - CID 1437 - FMI 05
2009/04/27 How Is Service Information Accessed / Used {1000}
C13 Tier 4 Final Engines General Information - C13 Engines
C9.3 Engines for Caterpillar Built Machines Injector Trim File - Install
C-15 and C-16 Industrial Engines Engine Speed/Timing Sensors - Check/Clean/Calibrate
C13 Engines for Caterpillar Built Machines Ignition Coil - Remove and Install - Clean Emissions Module
C-15 Petroleum Engine Engine Speed/Timing Sensors - Check/Clean/Calibrate
Improved Outlet Pipe for the Turbocharger{1052, 1353} Improved Outlet Pipe for the Turbocharger{1052, 1353}