Exhaust Manifold
Show/hide table
| |
| Illustration 1 | g01421493 |
|
Typical example (1) Cylinder head | |
(2) Torque for 12 taperlock studs ...
(3) Torque for four taperlock studs ...
(4) Install the gasket with the tab upward, as shown.
(5) Apply 4C-5599 Anti-Seize Compound to the threads of the locknuts and the bearing surface of the locknuts and the washers before assembly.
Caterpillar Information System:
3608 Engine Idler Gears (Rear) - Install
3608 Engine Idler Gears (Rear) - Remove
3608 Engine Crankshaft Rear Seal - Install
C15 and C18 Petrolem Generator Set Engines Cat Data Link - Test
C15 and C18 Petrolem Generator Set Engines CAN Data Link - Test
C15 and C18 Petrolem Generator Set Engines Sensor Supply - Test
C11 and C13 Engines Engine Oil Filter Base
C-10 and C-12 Truck Engines Piston and Rings
G3520B Engine Control Panel - If Equipped
G3406 and G3412 Generator Set Engines Vibration Damper and Pulley
C13 Engine Crankshaft - Install
C13 Engine Crankshaft Main Bearings - Install
3176C and 3196 Engines for Caterpillar Built Machines Exhaust Manifold
2007/10/01 A New Base for the Engine Oil Cooler and Engine Oil Filter is Now Used {1306, 1378}
2007/10/15 An Improved Air Cleaner Assembly is Now Used {1051, 1054}
3608 Engine Camshaft - Remove
3608 Engine Valve Mechanism - Install
2007/10/22 The Programmable Monitoring System Parameters Have New Descriptions {1901, 1902, 7620}
3608 Engine Rocker Arm - Disassemble
3608 Engine Vibration Damper - Remove
C-10 and C-12 Truck Engines Exhaust Manifold
C-10 and C-12 Truck Engines Exhaust Manifold
3608 Engine Crankcase Explosion Relief Valve - Remove and Install
3608 Engine Governor - Remove