Idler Gears (Rear) - Remove
Removal Procedure
Start By:
- Remove the camshaft drive gear. Refer to Disassembly and Assembly, "Camshaft Drive Gear - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Attach a suitable lifting device to the idler gear assembly. The weight of the idler gear assembly is approximately 54 kg (119 lb). Remove bolts (1) and retainer (2). Remove the idler gear assembly from the shaft.
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
Show/hide table
Illustration 1 | g01421422 |
Note: It is not necessary to remove the rear housing in order to remove the rear idler gears.
- Disassemble the idler gear assembly:
- Remove bolts (6). Separate gear (5) from gear (4) .
- If necessary, remove bearing (3) from gear (4) .
- Remove thrust washer (8) .
- Attach a suitable lifting device to shaft (7). The weight of shaft (7) is approximately 25 kg (55 lb). Remove bolts (9). Remove shaft (7) from the cylinder block.
- If necessary, remove the dowel from shaft (7) .
Caterpillar Information System:
3608 Engine Crankshaft Rear Seal - Install
C15 and C18 Petrolem Generator Set Engines Cat Data Link - Test
C15 and C18 Petrolem Generator Set Engines CAN Data Link - Test
C15 and C18 Petrolem Generator Set Engines Sensor Supply - Test
C11 and C13 Engines Engine Oil Filter Base
C-10 and C-12 Truck Engines Piston and Rings
G3520B Engine Control Panel - If Equipped
G3406 and G3412 Generator Set Engines Vibration Damper and Pulley
C13 Engine Crankshaft - Install
C13 Engine Crankshaft Main Bearings - Install
C27 and C32 Industrial and Petroleum Engines Turbocharger
C27 and C32 Industrial and Petroleum Engines Turbocharger
3608 Engine Idler Gears (Rear) - Install
3176C and 3196 Engines for Caterpillar Built Machines Exhaust Manifold
3176C and 3196 Engines for Caterpillar Built Machines Exhaust Manifold
2007/10/01 A New Base for the Engine Oil Cooler and Engine Oil Filter is Now Used {1306, 1378}
2007/10/15 An Improved Air Cleaner Assembly is Now Used {1051, 1054}
3608 Engine Camshaft - Remove
3608 Engine Valve Mechanism - Install
2007/10/22 The Programmable Monitoring System Parameters Have New Descriptions {1901, 1902, 7620}
3608 Engine Rocker Arm - Disassemble
3608 Engine Vibration Damper - Remove
C-10 and C-12 Truck Engines Exhaust Manifold
C-10 and C-12 Truck Engines Exhaust Manifold