Capacities (Refill)
Show/hide table
| Compartment or System | Liters | US Gallons | Imperial Gallon |
| Transmission System (Sump Refill Capacity) | 34.8 | 9.2 | 7.7 |
The refill capacities that are listed in Table 1 are for filling the transmission during routine maintenance. Initial system fills or refills after system repairs will require additional oil in order to fill the oil filter lines, and the oil filters. This additional amount of oil will vary between Original Equipment Manufacturers due to different lengths of hoses that are used for the oil filter lines. Refer to Operation and Maintenance Manual, "Transmission Oil Level - Change" for the proper procedure in order to fill the transmission.
Note: Any component added to the transmission will change the quantity of the the refill capacity.
Caterpillar Information System:
TA19-M2WD and TA19-M4WD Agricultural Transmissions Lifting and Tying Down the Transmission
C280-6 and C280-8 Engines Exhaust Manifold - Remove and Install - C280-8
C280-6 and C280-8 Engines Exhaust Manifold - Remove and Install - C280-6
C280-12 and C280–16 Marine Engines Exhaust Manifold - Remove and Install - C280-16
C280-12 and C280–16 Marine Engines Exhaust Manifold - Remove and Install - C280-12
TA19-M2WD and TA19-M4WD Agricultural Transmissions Transmission Control
3512C and 3516C Marine Auxiliary and Generator Set Engines Air Shutoff - Test - Engines That Are Equipped with ADEM II or ADEM III Engine Control Modules (If equipped)
3512C and 3516C Marine Auxiliary and Generator Set Engines Maintenance Recommendations
3512C and 3516C Marine Auxiliary and Generator Set Engines Safety Messages
Installation Instructions For UPS 1200 With Paralleling{4480} Installation Instructions For UPS 1200 With Paralleling{4480}
3608 Engine Crankshaft - Install
UPS 1000S and UPS 1200S Uninterruptible Power Supplys , Parallel Serial Number Plate
TA19-M2WD and TA19-M4WD Agricultural Transmissions Breather (Transmission) - Clean
TA19-M2WD and TA19-M4WD Agricultural Transmissions Transmission Oil - Change
Bench Test Procedure For A TH48FT - E70 Oil Field Transmission {3030} Bench Test Procedure For A TH48FT - E70 Oil Field Transmission {3030}
TA19-M2WD and TA19-M4WD Agricultural Transmissions Transmission Oil Level - Check
TA19-M2WD and TA19-M4WD Agricultural Transmissions Transmission Suction Screen - Clean
C0.5 and C0.7 Industrial Engines Fuel Injector - Test/Change
2006/11/13 New Software is Now Available for EMCP 3.1, EMCP 3.2, and EMCP 3.3 {4490, 7620}
2006/10/16 New Software Available for Product Link {7606, 7620}
C280-12 and C280–16 Marine Engines Engine Lifting Bracket - Remove and Install
TA19-M2WD and TA19-M4WD Agricultural Transmissions Maintenance Interval Schedule
C280-6 and C280-8 Engines Engine Lifting Bracket - Remove and Install
C0.5 and C0.7 Industrial Engines Cooling System Water Temperature Regulator - Replace