Electronic Control Module - Remove and Install
Removal Procedure
Start By:
- Remove the fuel cooler. Refer to Disassembly and Assembly, "Fuel Cooler - Remove and Install".
- Loosen bolt (1). Disconnect harness assembly (2) from electronic control module (4) .
Show/hide table
 | |
| Illustration 1 | g01242084 |
- Remove bolts (3). Remove electronic control module (4) from the engine.
Installation Procedure
- Position electronic control module (4) onto the engine. Install bolts (3) .
Show/hide table
| | |
| Illustration 2 | g01242084 |
- Connect harness assembly (2). Tighten bolt (1) to a torque of 6 ± 1 N·m (53 ± 9 lb in).
End By: Install the fuel cooler. Refer to Disassembly and Assembly, "Fuel Cooler - Remove and Install".
Caterpillar Information System:
C9 On-highway Engine Water Temperature Regulator Housing
C15 and C18 Generator Set Engines Event Codes
UPS 120, UPS 150, UPS 250 and UPS 300 Uninterruptible Power Supplies Pager Configuration
3508C, 3512C and 3516C Marine Engines Accessory Drive (Front) - Install - Engine Oil Pump and Water Pump
Procedure for Adding Filtration Capability to Solvent Stands {0680} Procedure for Adding Filtration Capability to Solvent Stands {0680}
C15 and C18 Generator Set Engines E085 Engine Shutdown Overridden
3512 Industrial Engine Engine Design
3512C and 3516C Engines Prelubrication System
C15 and C18 Generator Set Engines E197 High Engine Oil Temperature
3508C, 3512C and 3516C Marine Engines Accessory Drive (Front) - Remove - Engine Oil Pump and Water Pump
Electronic Injector Height Adjustment and Setting{1251, 1290} Electronic Injector Height Adjustment and Setting{1251, 1290}
3512C and 3516C Engines Engine Speed/Timing Sensor
3508C, 3512C and 3516C Marine Engines Housing (Front) - Remove
C7 Marine Engines Unit Injector Hydraulic Pump - Remove
C15 and C18 Petrolem Generator Set Engines Diagnostic Code Cross Reference
C7 Marine Engines Unit Injector Hydraulic Pump - Install
3500 Engines Housing (Front) - Install
C13, C15, and C18 Generator Set Engines CID 1690 FMI 08 Throttle #2 Position Sensor abnormal frequency, pulse width, or period
3406E, C-10, C-12, C-15, C-16 Truck Engines Reference Material
D Series Excavator Monitoring System Performance Mode
3500 Engines Balancer Group (Front) - Remove and Install - 3508C Engine
3512C and 3516C Engines Pulse Width Modulated Sensor
C7 Marine Engines Oil Cooler (Transmission, Auxiliary) - Remove and Install
2006/04/17 Slide Sledge Heavy Equipment Repair Tools Are Now Available {0599, 0644}