Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | FT-1114 | Vacuum Cap | 1 |
5P-0306 | Vacuum Transducer | 1 | |
6V-4142 | Fitting | 1 | |
5K-5068 | Fitting | 1 |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
- Position control manifold (7) and install bolts (6).
- Connect hose assemblies (8).
- Connect harness assemblies (5).
- Connect tube assembly (4).
Show/hide table
Illustration 2 g01172139 - Install panel assembly (3).
Show/hide table
Illustration 3 g01172138 - Rotate roading fender (2) inward and lower hood (1).
Show/hide table
Illustration 4 g01172128 - Remove Tooling (A) and install the hydraulic tank cap.
Illustration 1 | g01172171 |
End By:
- Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".