Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | FT-1114 | Vacuum Cap | 1 |
5P-0306 | Vacuum Transducer | 1 | |
6V-4142 | Fitting | 1 | |
5K-5068 | Fitting | 1 |
Start By:
- Release the hydraulic system pressure. Refer to Disassembly and Assembly, "System Pressure - Release".
- Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
- Remove the hydraulic tank cap and install Tooling (A). Apply
276 kPa (40 psi) to414 kPa (60 psi) of air pressure to Tooling (A).Show/hide tableIllustration 2 g01172138 - Raise hood (1) and rotate roading fender (2) outward.
Show/hide table
Illustration 3 g01172139 - Remove panel assembly (3).
Show/hide table
Illustration 4 g01172171 - Disconnect tube assembly (4).
- Disconnect harness assemblies (5).
- Disconnect hose assemblies (8).
- Remove bolts (6) and control manifold (7).
Illustration 1 | g01172128 |