Bucket Positioner
Show/hide table
Illustration 1 | g00953110 |
- Raise the bucket and dump the bucket. Move the tilt control lever to TILT BACK detent position.
- When the present bucket angle is reached, the control lever returns to HOLD position. Lower the bucket and check the cutting angle.
- Position the bucket on the ground.
Show/hide table
Illustration 2 | g00986425 |
Single Lever Control
- Move the single lever control to position (1) in order to raise the bucket. Move the single lever control to position (4) in order to dump the bucket. Move the single lever control to TILT BACK detent position (3) .
Show/hide table
Illustration 3 | g01000356 |
- When the present bucket angle is reached, the single lever control returns to HOLD position. Move the control lever to position (2) in order to lower the bucket and check the cutting angle.
- Position the bucket on the ground.
Adjust:
Show/hide table
Illustration 4 | g00994767 |
- Loosen bolts (1) while you tighten screw (2) in order to adjust the bucket positioner. Horizontally center bucket positioner switch assembly (3) over magnet (4) .
- Tighten bolts (1) in order to secure this position.
- Callout (A) is the dimension from the switch to the magnet. The correct measurement is 5 mm (0.20 inch) to 7 mm (0.28 inch).
Caterpillar Information System:
953C Track-Type Loader Monitoring System
994 Wheel Loader Steering System Steering Metering Pump
953C Track-Type Loader Light Switches
966G and 972G Wheel Loaders Transmission Control - Command Control Steering
992G Wheel Loader Electrohydraulic System Pilot Control Actuator Current (Proportional Solenoid) - Check
611 Wheel Tractor-Scraper 3306B Engine Supplement Radiator - Remove
953C Track-Type Loader Window Wiper and Washer Control
953C Track-Type Loader Heating and Air Conditioning Controls - If Equipped
627F Wheel Tractor-Scraper Heating and Air Conditioning Control
631E Series II Wheel Tractor-Scrapers Backup Alarm
621F Wheel Tractor-Scraper Horn
953C Track-Type Loader Engine Start Switch
953C Track-Type Loader Tracks
966G and 972G Wheel Loaders Transmission Control - Conventional Steering
613C Series II Wheel Tractor 3116 Engine Supplement Radiator - Disassemble
3306B Industrial Engine Walk-Around Inspection
966G and 972G Wheel Loaders Autoshift Control - Earlier Machines
611 Wheel Tractor-Scraper 3306B Engine Supplement Fan and Fan Drive - Remove
613C Series II Wheel Tractor 3116 Engine Supplement Radiator - Assemble
966G and 972G Wheel Loaders Implement Lockout Control
994 Wheel Loader Hydraulic System Linkage Pin and Seal Group (Bucket Control)
953C Track-Type Loader Shipping the Machine
953C Track-Type Loader Stopping the Engine
953C Track-Type Loader Changing Direction and Speed