Connecting Rod Bearings - Remove
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 9S-9082 | Engine Turning Tool | 1 |
Start By:
- Remove the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Check the connecting rod and the connecting rod bearing caps for identification and the orientation on the crankshaft.
- Use Tooling (A) and turn the crankshaft until the connecting rod bearing caps are accessible.
Show/hide table
Illustration 1 g00886583 - Remove bolts (1). Remove connecting rod bearing cap (2) from the connecting rod.
Show/hide table
Illustration 2 g00886587 - Remove rod bearing (3) from connecting rod bearing cap (2).
- Push the connecting rod away from the crankshaft. Remove the upper half of rod bearing (3) from the connecting rod.
Caterpillar Information System:
3056E Industrial Engine Crankshaft
3412E, C30 and C32 Marine Engines Pistons and Connecting Rods - Install
K65-12B Voltage Regulator Stability - Adjust
3054 and 3056 Industrial and Generator Set Engines Engine Oil Filter Base
K65-12B Voltage Regulator Dimensions
C7 and C9 On-Highway Engines Cooling Fan Circuit and A/C High Pressure Switch Circuit - Test
3126B and 3126E On-highway Engines 0111-04 Coolant Level voltage low (12)
PMG3516 Power Module Fuel Metering Valve - Check - Raptor
3412E, C30 and C32 Marine Engines Pistons and Connecting Rods - Install
3500 Generator Set Engines Engine Oil Cooler Bypass and Cooling Jet Sequence Valves
Electronic Modular Control Panel II (EMCP II) EMCP Electronic Control (Generator Set) - Replace
3412E, C30 and C32 Marine Engines Pistons and Connecting Rods - Remove
K65-12B Voltage Regulator Voltage - Adjust
K65-12B Voltage Regulator Droop - Adjust
3054 and 3056 Marine Generator Set Engines Engine Oil Cooler
330C Excavator Machine System Specifications Recoil Spring
797B Off-Highway Truck Air System Pressure Protection Valve (Air System)
3412E, C30 and C32 Marine Engines Crankshaft - Remove
2007/08/20 C-12/3176C/3196 Front Housing Bolts {1151}
3126B and 3126E On-highway Engines Injection Actuation Pressure - Test
2002/07/01 Front Housing Bolts for the C-10 and C-12 {1151}
3306C Engines for Caterpillar Built Machines Alternator and Regulator
3126B Truck Engine Fuel Recommendations
3126B and 3126E On-highway Engines Customer Specified Parameters