Water Pump - Install - 3054 Engine
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Inspect the condition of the gasket. Replace the gaskets, if necessary.
- Install the gasket and water pump (2) to the front housing.
Show/hide table
Illustration 1 | g00804305 |
Show/hide table
Illustration 2 | g00804303 |
- Install eight bolts (1) and install two bolts (3) that fasten the water pump (2) to the front housing.
- Tighten hose clamp (4) .
- Fill the cooling system. If the engine uses diesel engine antifreeze/coolant, refer to Operation and Maintenance Manual, "Cooling System Coolant (DEAC) - Change". If the engine uses extended life coolant, refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change".
Caterpillar Information System:
3054 and 3056 Industrial and Generator Set Engines Water Pump - Inspect
Electronic Modular Control Panel II (EMCP II) Pulse Width Modulated Sensor
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Swivel - Assemble
3054 and 3056 Marine Generator Set Engines Water Pump - Remove - 3054 Engine
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Swivel - Disassemble
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Swivel - Install
3054 and 3056 Marine Generator Set Engines Engine Oil Cooler - Remove and Install - 3054 Engine
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Swivel - Remove
Electronic Modular Control Panel II (EMCP II) Charging System
Electronic Modular Control Panel II (EMCP II) SP Fault Code
3054 and 3056 Marine Generator Set Engines Engine Oil Filter Base - Install - 3056 Engine
3054 and 3056 Marine Generator Set Engines Engine Oil Filter Base - Remove - 3056 Engine
2014/02/07 The 127-2450 Cylinder Head Kit Includes A New Cylinder Head Group {1100}
Electronic Modular Control Panel II (EMCP II) Indicator for Emergency Stop (for EUI Engines)
3054 and 3056 Marine Generator Set Engines Heat Exchanger - Remove - 3056 Engine
3054 and 3056 Marine Generator Set Engines Heat Exchanger - Install - 3056 Engine
Electronic Modular Control Panel II (EMCP II) Indicator for Emergency Stop (for MUI Engines)
3054 and 3056 Marine Generator Set Engines Heat Exchanger - Remove - 3054 Engine
2002/06/01 A New Valve Adjusting Screw Is Available {1123}
Electronic Modular Control Panel II (EMCP II) Indicator for High Water Temperature
Electronic Modular Control Panel II (EMCP II) Indicator for Low Oil Pressure
EMCPII+ for Gas Engines Indicator for Overcrank
Electronic Modular Control Panel II (EMCP II) Typical Generator Abbreviations
3054 and 3056 Industrial and Generator Set Engines Automatic Timing Advance Unit - Test