Clock Adjustment
Show/hide table
Illustration 1 | g00677105 |
(1) Up key (2) Right key (3) Set key (4) Menu key (5) Left key (6) Down key (7) Cancel key (8) OK key |
Show/hide table
    |     |     |
    | MAIN MENU     |     |
    | PREFERENCES     |     |
    | SELECT TOOL     |     |
    | FLTR/FLUID INFO     |     |
    |     |     |
- Press up key (1) or press down key (6) in order to highlight the "PREFERENCES" menu. Press OK key (8).
Show/hide table
Table 2                 PREFERENCE MENU             SELECT LANGUAGE             SET CLOCK             ADJUST DISPLAY                    
- Press up key (1) or press down key (6) in order to highlight the "SET CLOCK" menu. Press OK key (8).
Show/hide table
Table 3                 SET CLOCK             00 : 00                                            
- Press left key (5) or press right key (2) in order to select the hour or the minute. Press up key (1) in order to increase the number. Press down key (6) in order to decrease the number.
- When the clock is set to the desired time, press set key (3) .
Note: Press cancel key (7) in order to return to the default display.
Caterpillar Information System:
307C Excavator Hydraulic System Relief Valve (Main) - Test and Adjust
SG16 Stump Grinder Work Tool Systems Stump Grinder Wheel
Machine Security System Electronic Control Module (ECM) - Replace
Machine Security System System Schematic
Machine Security System General Information
Machine Security System General Information
307C Excavator Hydraulic System Pump Control (Output Flow) - Adjust
307C Excavator Light Switches
320C Excavator Power Receptacle - If Equipped
330C Excavator Battery Disconnect Switch
320C Excavator Plate Locations and Film Locations
3126B Engines for Caterpillar Built Machines Electronic Control Module - Remove and Install
307C Excavator Travel Alarm - If Equipped
330C Excavator Light Switches
2000/08/28 New Hydraulic Oil Coolers with Copper-Nickel Alloy Tubes Resist Corrosion {1374}
2000/08/07 The Assembly Procedure for the Main Hydraulic Pump Is Changed {5070}
307C Excavator Hydraulic System Relief Valve (Swing) - Test and Adjust
JF Series Starting Motor Pinion Does Not Engage Ring Gear While Armature Turns
JF Series Starting Motor Starting Motor Continues to Operate after Start Switch Has Been Released
M318 Excavator Hydraulic System Relief Valve (Line) - Test and Adjust - Travel Motor
2000/10/30 Part Numbers for Electric Motors That Are Used in HVAC Have Changed {5927}
JF Series Starting Motor Starting Motor Solenoid - Test
307C Excavator Hydraulic System Main Pump (Flow) - Test
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket - Remove and Install