Engine Overspeeds on Start
- Problem with the fuel injection control linkage
- Problem with the governor
Problem With the Fuel Injection Control Linkage
Inspect the fuel injection control linkage. Look for the following conditions:
- Improper assembly after overhaul
- Linkage that is binding
- Linkage that is stuck in the Fuel ON position
- Governor output shaft that is disconnected from the fuel injection control linkage
Refer to Troubleshooting, "Fuel Injection Control Linkage" for further information. Make repairs or replace components, if necessary.
If a problem with the governor is suspected, refer to Troubleshooting, "Governor Instability". If the problem can not be resolved, remove the governor and bench test the governor. If the governor can not be adjusted properly during the bench test, repair the governor or replace the governor. Bench test the repaired governor. If the governor must be replaced, bench test the new governor. Refer to Service Manual, SENR6454, "3114, 3116 & 3126 Engine Governors".
Caterpillar Information System:
3034 Industrial Engine Cold Weather Starting
G3612 and G3616 Engines Air Inlet Elbow - Remove and Install
G3612 and G3616 Engines Air Inlet Choke - Assemble
3114, 3116 and 3126 Engines Engine Misfires, Knocks, or Is Unstable (at Idle Only)
G3612 and G3616 Engines Air Inlet Choke - Disassemble
G3612 and G3616 Engines Air Inlet Choke - Remove
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 445 FMI 12 Run Relay Failed - Test
G3612 and G3616 Engines Junction Box (Hydrax) - Remove and Install
C9 On-Highway Truck Engines Unit Injector Hydraulic Pump - Remove
Generator Set Load Sensor Phasing - Adjust
3114, 3116 and 3126 Engines Alternator Noise
G3612 and G3616 Engines Hydraulic Tank (Hydrax) - Remove and Install
G3612 and G3616 Engines Air Starting Motor - Disassemble
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 446 FMI 12 Air Shutoff Relay Failed - Test
SR4B Generators Generator - Install
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 447 FMI 12 Fuel Control Relay Failed - Test
3044C Industrial Engine Fuel Conservation Practices
G3612 and G3616 Engines Generator - Remove and Install
3500B Engines Water Pump - Install
G3304 and G3306 Engines Valve Cover
3126B and 3126E On-highway Engines Unit Injector Hydraulic Pump - Install
G3304 and G3306 Engines Valve Cover
3306C Engines for Caterpillar Built Machines Gear Group (Front)
G3304 and G3306 Engines Engine Support