Junction Box (Hydrax) - Remove and Install
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 卸下四个螺钉 (1),以便拉开盖(未显示)。
- 断开电气连接 (2)。
- 卸下四个螺钉 (3)。
Show/hide table
图 2 g00597176 - 取下四个螺钉 (4),以便卸下驱动器模块 (5) 和驱动器模块 (6)。
Show/hide table
图 3 g00597177 - 卸下固定其余驱动器模块 (8) 的四个螺钉 (7)。 卸下驱动器模块 (8)。
Show/hide table
图 1 | g00597175 |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 将驱动器模块 (8) 定位在支架内。 安装四个螺钉 (7)。
Show/hide table
图 5 g00597176 - 定位驱动器模块 (5) 和驱动器模块 (6)。 安装四个螺钉 (4)。
Show/hide table
图 6 g00597175 - 将驱动器模块 (8) 定位在驱动器模块 (5) 和驱动器模块 (6) 之间。 安装四个螺钉 (3)。
- 连接电气连接 (2)。
- 定位盖(未显示)。 安装四个螺钉 (1)。
Show/hide table
图 4 | g00597177 |
Caterpillar Information System:
C9 On-Highway Truck Engines Unit Injector Hydraulic Pump - Remove
Generator Set Load Sensor Phasing - Adjust
3114, 3116 and 3126 Engines Alternator Noise
G3612 and G3616 Engines Hydraulic Tank (Hydrax) - Remove and Install
G3612 and G3616 Engines Hydraulic Oil Pump (Hydrax) - Remove and Install
3500B Engines Air Inlet Manifold - Remove and Install
G3612 and G3616 Engines Caterpillar Ignition System (CIS) Module - Remove and Install
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 444 FMI 12 Starting Motor Relay Failed - Test
G3612 and G3616 Engines Actuator (Hydrax) - Assemble
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 443 FMI 12 Crank Termination Relay Failed - Test
G3612 and G3616 Engines Actuator (Hydrax) - Disassemble
G3612 and G3616 Engines Actuator (Hydrax) - Install
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 445 FMI 12 Run Relay Failed - Test
G3612 and G3616 Engines Air Inlet Choke - Remove
G3612 and G3616 Engines Air Inlet Choke - Disassemble
3114, 3116 and 3126 Engines Engine Misfires, Knocks, or Is Unstable (at Idle Only)
G3612 and G3616 Engines Air Inlet Choke - Assemble
G3612 and G3616 Engines Air Inlet Elbow - Remove and Install
3034 Industrial Engine Cold Weather Starting
3114, 3116 and 3126 Engines Engine Overspeeds on Start
G3612 and G3616 Engines Air Starting Motor - Disassemble
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 446 FMI 12 Air Shutoff Relay Failed - Test
SR4B Generators Generator - Install
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 447 FMI 12 Fuel Control Relay Failed - Test