Oil Pump Drive
Usage:
(1) End play for shaft ... .003 to .019 in.(0.08 to 0.48 mm)
(2) Length of shaft from bracket ... 1.625 ± .010 in.(41.28 ± 0.25 mm)
(3) Diameter of the shaft for the drive idler gear ... 1.2475 to 1.2485 in.(31.687 to 31.712 mm)
Bore in bearing for the shaft ... 1.2510 ± .0015 in.(31.775 ± 0.038 mm)
(4) Diameter of the drive shaft for the oil pump ... .7410 ± .0005 in.(18.821 ± 0.013 mm)
Bore in bearing for the drive shaft for the oil pump ... .744 ± .001 in.(18.90 ± 0.03 mm)
(5) The "V" mark on idler shaft (5) must be in alignment with "V" mark on bracket.
(6) The "V" mark on bearing (6) must be in alignment with "V" mark on bracket.
Caterpillar Information System:
G342 ENGINE Oil Pump Valves
G342 ENGINE Oil Pump
G342 ENGINE Cylinder Head (Engines Without Spacer Plates)
G342 ENGINE Cylinder Head (Engines With Spacer Plates
G342 ENGINE Camshaft
G342 ENGINE Valves
G342 ENGINE Service Meter
G342 ENGINE Timing Gears
G342 ENGINE Valve Rocker Arms And Lifters
G342 ENGINE Turbocharger (Schwitzer 4MD354)
G342 ENGINE Governor Linkage
G342 ENGINE Governor And Magneto Drive
G342 ENGINE Oil Filter
G342 ENGINE Oil Filter Base (2S8877 Oil Filter Assembly)
G342 ENGINE Oil Filter Base (6L3714 Oil Filter Assembly)
G342 ENGINE Water Pump
G342 ENGINE Auxiliary Water Pump
G342 ENGINE Fan Drive
G342 ENGINE V-Belt Tension Chart
G342 ENGINE Water Pump Idler Gear
G342 ENGINE Cooling System Pressure Cap (6L8617)
G342 ENGINE Water Temperature Regulators (4L7615)
G342 ENGINE Water Temperature Regulators (9N2894 And 9S9160)
G342 ENGINE Cylinder Block (Engines With Spacer Plate)