Removal Procedure
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
Note: Disconnect all electrical connections to the engine oil pressure switch before proceeding. Mark all connections for later installation.
- Remove engine oil pressure switch (1) from the engine.
Illustration 1 | g00590032 |
3003 Engine |
Illustration 2 | g00590039 |
3013, 3014, and 3024 Engines |
Installation Procedure
- Apply a thin layer of 5P-3413 Pipe Sealant to the threads of engine oil pressure switch (1) .
Illustration 3 | g00590032 |
3003 Engine |
Illustration 4 | g00590039 |
3013, 3014, and 3024 Engines |
- Install engine oil pressure switch (1) in the engine. Tighten the engine oil pressure switch to a torque of 11 N·m (8 lb ft).
Note: Reconnect all electrical connections to the engine oil pressure sensor before you operate the engine.