Engine Lifting Bracket - Remove and Install
拆卸步骤
Show/hide table
所需工具     | |||
工具     | 零件号     | 零件说明     | 数量     |
A     | 185-5192     | 双头螺栓保护装置     | 4     |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
Show/hide table
图 1 | g00538198 |
G3606 发动机 |
Show/hide table
图 2 | g00538154 |
G3608 发动机 |
- 拆下螺栓 (3) 。
- 从提升支架上卸下盖 (4) 。
注: 发动机投入使用后,应立即卸下提升支架。
- 拆下螺母 (2) 。
Show/hide table
图 3 | g00538157 |
注: 必须卸下"气体阀门" (X) 和管组件以便卸下提升支架。 开始此步骤前,请"关闭"外部供油。
- 卸下提升支架 (1) 。
- 将工具 (B) 安装在每个缸盖螺柱上。
注: 将提升支架存储在一个清洁、干燥的地方。 直到需要提升发动机时,才需安装提升支架。
安装步骤
Show/hide table
所需工具     | |||
工具     | 零件号     | 零件说明     | 数量     |
A     | 185-5192     | 双头螺栓保护装置     | 4     |
B     | 5P-3931     | 防粘结剂     | 1     |
- 从缸盖螺柱上卸下工具 (A) 。
- 将工具 (B) 涂在缸盖螺柱的螺纹上。
注: 将提升支架安装在以下油缸之间的 G3606发动机上:
- 1 号油缸和 2 号油缸
- 5 号油缸和 6 号油缸
注: 将提升支架安装在以下油缸之间的 G3608发动机上:
- 1 号油缸和 2 号油缸
- 7 号油缸和 8 号油缸
- 1 号油缸和 2 号油缸
- 将提升支架 (1) 放在缸盖螺柱上的合适位置。
- 安装螺母 (2) 。 将每个螺母拧紧至扭矩 2150 ± 250 N·m (1585 ± 185 lb ft)。
- 安装气体阀门和管道组件。 "接通"外部供油。
Caterpillar Information System:
3176C Engine Air Inlet and Exhaust System
G3300 Engines Walk-Around Inspection - Exercise Inspection of Standby Generator Set Engines
3406E Generator Set Engines Hoses and Clamps - Replace
G3300 Engines Governor - Inspect
Digital Voltage Regulator Wiring Diagrams
Digital Voltage Regulator Troubleshooting
Digital Voltage Regulator Watchdog Alarm - Troubleshoot
Digital Voltage Regulator Unstable Voltage - Troubleshoot
Digital Voltage Regulator Reverse VAR Condition - Troubleshoot
Digital Voltage Regulator No Voltage - Troubleshoot
Digital Voltage Regulator Low Voltage - Troubleshoot
Digital Voltage Regulator Loss of Frequency Shutdown - Troubleshoot
322B, 322B L, 325B and 325B L Excavators Final Drive Oil - Change
G3606 and G3608 Engines Engine Support - Remove and Install
3412E and C30 Marine Engines Auxiliary Water Pump (Rubber Impeller) - Inspect
G3300 Engines Ignition System Spark Plug Wires - Replace - Standard Ignition Systems
3412E and C30 Marine Engines Auxiliary Water Pump (Bronze Impeller) - Inspect
G3300 Engines Engine Performance - Test
G3606 and G3608 Engines Mounting Isolator - Remove and Install
TK711, TK721, TK722 and TK732 Track Feller Bunchers Final Drive Oil Level - Check
3408C, 3412C and 3412D High Performance Marine Engines Engine Oil Lines
3054 Truck Engine Model View Illustrations
3054 Truck Engine Engine Description
G3606 and G3608 Engines Electric Starting Motor - Remove and Install