Fuel Injection Pump Housing
Show/hide table
Illustration 1 | g00368853 |
(1) The bearing is flush with the edge of the housing. Tolerance ... ± 0.05 mm (± 0.002 inch)
(3) The bearing is installed from the edge of the housing by the following value. ... 0.8 ± 0.5 mm (0.032 ± 0.02 inch)
Show/hide table
Illustration 2 | g00705906 |
Area A |
For bearings (2) and (3) , the bearings' joint clearance must be within 10 ± 1 degrees of the top center. Refer to (6) Illustration 2 for further information.
(5) The distance from the bottom of the housing to the end of the dowel ... 1.60 ± 0.45 mm (0.063 ± 0.0178 inch)
Caterpillar Information System:
3408E and 3412E Engines for Caterpillar Built Machines Connecting Rod
3408E and 3412E Engines for Caterpillar Built Machines Connecting Rod and Main Bearing Journals
3412 Generator Set Engines Crankshaft
3412 Generator Set Engines Engine Oil Temperature Sensor
3406C Engines for Caterpillar Built Machines Cylinder Liner Projection
3034 Engine for Caterpillar Built Machines Water Pump
3034 Engine for Caterpillar Built Machines Water Temperature Regulator
3412 Generator Set Engines Electrical System
3412 Generator Set Engines Cylinder Liner
3034 Engine for Caterpillar Built Machines Fuel Injection Nozzles
3412 Generator Set Engines Coolant Temperature Switch
3408E and 3412E Engines for Caterpillar Built Machines Camshaft Bearings
3412 Generator Set Engines Piston and Rings
3408C, 3412C and 3412D High Performance Marine Engines Troubleshooting
3034 Engine for Caterpillar Built Machines Inlet Manifold
3034 Engine for Caterpillar Built Machines Exhaust Manifold
3618 Engine Engine Operation
3034 Engine for Caterpillar Built Machines Fuel Injection Pump
3618 Engine Tools
3412 Generator Set Engines Speed/Timing Sensor
3412 Generator Set Engines Flywheel Housing
3500B Locomotive Engines Model View Illustrations
3412 Generator Set Engines Fuel Pressure Indicator
3412C Engine Engine Design