This function should only be used for small designs that can be easily placed by the machine operator. The altered position of the design is stored in the file as an offset and is applied to the design whenever the file is opened.
Note: Files with this function cannot be used with older versions of the on-board software. The reference point to which the design is rotated can be set. If the reference point is not set, the point will be set by default to the middle of the west end of the box surrounding the design.
Before a design can be moved in to the on-board software, the option that is used to enable this feature in the design file must be selected in Cat MineStar System.
Reference: Refer to Systems Operation, RENR9562, "Terrain Office Software".
"Design File Move Enable" - Enables the Move Design option in the on-board software menu.
Note: By default this option is turned off and the option to "Move Design" is hidden.
"Allow All Design File Moves" - Allows all files to be moved.
Note: Each file has a permission flag. This flag is like the change offset flag that allows operators to move a design. This setting will allow all files, including old designs, to be moved.