Valve Covers
Usage:
Remove & Install Valve Covers
1. Remove seven bolts (1).
2. Remove valve cover (2).
NOTE: The following steps are for the installation of the valve covers.
3. Make sure the seal is in position on the valve cover.
4. Install seven bolts (1).
5. Use the tightening sequence above to tighten the bolts to a torque of 14 ± 4 N·m (10 ± 3 lb ft).
Caterpillar Information System:
3412 GENERATOR SET ENGINES Exhaust Manifold
3412 GENERATOR SET ENGINES Turbocharger (Left Side & Rear) STA
3412 GENERATOR SET ENGINES Aftercooler Core
3412 GENERATOR SET ENGINES Air Cleaner
HEINZMAN GOVERNOR (3600 GENERATOR SET APPLICATIONS) Service Procedures
HEINZMAN GOVERNOR (3600 GENERATOR SET APPLICATIONS) Troubleshooting Heinzmann Electronic Speed Governors
HEINZMAN GOVERNOR (3600 GENERATOR SET APPLICATIONS) Testing And Adjusting
HEINZMAN GOVERNOR (3600 GENERATOR SET APPLICATIONS) Systems Operation
CONTROL PANEL (STATUS-TIMING) FOR 3500 SPARK IGNITED ENGINES Testing and Adjusting
CONTROL PANEL (STATUS-TIMING) FOR 3500 SPARK IGNITED ENGINES Systems Operation
ETR ELECTRICAL PROTECTION SYSTEM Service Procedures
ETR ELECTRICAL PROTECTION SYSTEM Troubleshooting Full Protection System - Energize To Run System - Oil Pressure, Water Temperature, Overspeed Protection
3412 GENERATOR SET ENGINES Rocker Shaft Assembly
3412 GENERATOR SET ENGINES Valve Lifters & Push Rods
3412 GENERATOR SET ENGINES Alternator
3412 GENERATOR SET ENGINES Cylinder Head
3412 GENERATOR SET ENGINES Valves
3412 GENERATOR SET ENGINES Valve Guides
3412 GENERATOR SET ENGINES Bridge Dowels
3412 GENERATOR SET ENGINES Valve Seat Inserts
3412 GENERATOR SET ENGINES Spacer Plates
3412 GENERATOR SET ENGINES Radiator
3412 GENERATOR SET ENGINES Fan
3412 GENERATOR SET ENGINES Belts