Electric Starting Motor
Usage:
Remove & Install Electric Starting Motor
1. Put identification marks on the wires for the starting motor as to their location on the starting motor. Disconnect all wires (3) from the starting motor.
2. Use two persons to remove the starting motor. The weight of the starting motor is 29 kg (64 lb). Remove three bolts (1) and starting motor (2) from the flywheel housing. Check the condition of the gasket for the starting motor. If necessary, make a replacement.
NOTE: The following steps are for installation of the electric starting motor.
3. Put the gasket and starting motor (2) in position on the flywheel housing, and install bolts (1) to hold it.
4. Connect all wires (3) to the starting motor.
Caterpillar Information System:
G3306B GENERATOR SET ENGINE Control Panels
G3306B GENERATOR SET ENGINE Control Panel Enclosure
G3306B GENERATOR SET ENGINE Battery Charger
3306B GENERATOR SET ENGINE Testing & Adjusting
3306B GENERATOR SET ENGINE Systems Operation
3306B GENERATOR SET ENGINE Flywheel Housing
3306B GENERATOR SET ENGINE Flywheel
3306B GENERATOR SET ENGINE Engine Front Support
3306B GENERATOR SET ENGINE Timing Gear Cover
3306B GENERATOR SET ENGINE Connecting Rod and Main Bearings
3306B GENERATOR SET ENGINE Bearing Surface (Journal) For Connecting Rods
3306B GENERATOR SET ENGINE Bearing Surface (Journal) For Main Bearings
G3306B GENERATOR SET ENGINE Fuel Injection Lines
G3306B GENERATOR SET ENGINE Fuel Injection Nozzles
G3306B GENERATOR SET ENGINE Fuel Injection Pump Housing & Governor
G3306B GENERATOR SET ENGINE Governor
G3306B GENERATOR SET ENGINE Fuel Injection Pumps
G3306B GENERATOR SET ENGINE Fuel Injection Pump Housing
G3306B GENERATOR SET ENGINE Fuel Transfer Pump
G3306B GENERATOR SET ENGINE Oil Filter & Oil Filter Base
G3306B GENERATOR SET ENGINE Oil Filter Base
G3306B GENERATOR SET ENGINE Fuel Priming Pump & Base
G3306B GENERATOR SET ENGINE Fuel Filter & Base
G3306B GENERATOR SET ENGINE Engine Oil Cooler