Usage:
1. Remove door (1).
2. Remove two bolts (2) from cover (3).
3. Remove doors (4).
4. Remove fourteen bolts (7) and cover (5).
5. Remove the battery charger. See the topic "Remove & Install Battery Charger".
6. Remove the bolts and cover (6).
7. Remove the three bolts located above the control panel and remove cover (3).
8. Identify and disconnect all the wires from breaker (9) and grounding buss (10).
9. Remove bolts (8), bracket (11), and breaker (9).
10. Identify and disconnect all wires (12) between the generator and the control panels from the terminal strips on the control panels.
11. Identify and disconnect all wires between the engine and control panels from the terminal strips on the control panels.
12. Remove bolts (13).
13. Install Tool (A) to enclosure (14) as shown, and fasten a hoist. It is necessary to remove one of the studs from the top of enclosure (14) before Tool (A) can be installed.
14. Remove enclosure (14).
Install Control Panel Enclosure.
1. Install Tool (A) to enclosure (14) as shown and fasten a hoist. It is necessary to remove one of the studs from the top of enclosure (14) before Tool (A) can be installed.
2. Put enclosure (14) in position on the base assembly for the generator set. Install bolts (13).
3. Remove the hoist and Tool (A). Install the stud in the top of enclosure (14).
4. Connect all wires (12) to the terminal strips on the control panels.
5. Connect all the wires from the engine to the terminal strips on the control panels.
6. Put bracket (11) and breaker (9) in position and install bolts (8).
7. Connect wires to breaker (9) and grounding buss (10). Install the battery charger. See the topic "Remove & Install Battery Charger".
8. Put cover (3) in position and install the three bolts above the control panel that hold cover (3) in place.
9. Put cover (6) in position and install the bolts that holds it in place.
10. Put cover (5) in position and install bolts (7). Install door (4).
11. Install two bolts (2) to cover (3). Install door (1).