Engine Oil Pump - Assemble
Assembly Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Inspect the condition of the O-ring seals. Replace O-ring seals, if necessary.
Note: Lubricate all internal parts of the engine oil pump with clean engine oil.
- Install drive shaft (3) in the housing.
Show/hide table
Illustration 1 | g01178186 |
- Raise the temperature of gear (6). Install gear (6) on the end of drive shaft (3) .
- Install idler gear (7) in the housing.
- Install O-ring seal (4) on housing (5) .
- Install cover (2) and bolts (1) .
Show/hide table
NOTICE |
---|
The pump must rotate freely by hand after assembly. |
End By: Install the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Install".
Caterpillar Information System:
Filtration Procedure for Hydraulic Oil in Compact Equipment {0680, 0768, 5050, 5056} Filtration Procedure for Hydraulic Oil in Compact Equipment {0680, 0768, 5050, 5056}
C-10 Petroleum Engine Engine Oil Pump - Disassemble
C6.6 Industrial Engine Introduction
C3.3 and C4.4 Rental Generator Sets Stopping the Engine
C280 Marine and Petroleum Engines Engine Speed/Timing Sensor
C-10 Petroleum Engine Engine Oil Pump - Remove
C9 Engine for Caterpillar Built Machines Cylinder Head - Install
C15 and C18 Engines for Caterpillar Built Machines Gear Group (Front)
C15 and C18 Engines for Caterpillar Built Machines Valve Rocker Arm
C2.2 Generator Sets Starting the Engine
C15 and C18 Engines for Caterpillar Built Machines Electronic Unit Injector Rocker Arm
2006/02/06 A New Exhaust Manifold Gasket is Used {1059}
C-10 Petroleum Engine Engine Oil Pump - Install
C18 Marine Engines Engine Oil Level Gauge - Calibrate
C13 On-highway Engine Water Pump
C13 Engine for Combat and Tactical Vehicles Atmospheric Pressure Sensor
C-10 Petroleum Engine Flywheel - Remove
C-10 Petroleum Engine Flywheel - Install
C9.3 Tier 4 Final Engines Engine Oil Pressure Sensor
C-10 Petroleum Engine Crankshaft Rear Seal - Remove
C27 and C32 Engines for Caterpillar Built Machines Coolant Temperature Sensor
C2.2 Generator Sets Refill Capacities and Recommendations
C7 and C9 Engines for Caterpillar Built Machines Injector Trim File
C4.4 and C6.6 Engines for Caterpillar Built Machines Alternator Noise