Alternator - Remove and Install
Removal Procedure
- Remove the lower access panel from the right hand side of the machine.
- Put identification marks on three wires (5). Disconnect wires (5) from the alternator.
Show/hide table
Illustration 1 | g00738266 |
- Remove two clips (3) that secure the wires to the alternator.
- Loosen bolts (1) and (4). Move the alternator toward the engine.
- Remove two V-belts (2) from the alternator pulley.
- Remove bolts (1) and (4). Remove alternator (6) from the machine.
Installation Procedure
- Put alternator (6) in position. Install bolts (1) and (4) .
Show/hide table
Illustration 2 | g00738266 |
- Install two V-belts (2) onto the alternator pulley.
- Move the alternator away from the engine in order to apply tension to the belts. Tighten bolts (1) and (4) .
- Install two clips (3) onto the wires.
- Connect wires (5) to the alternator.
- Install the lower access panel onto the right hand side of the machine.
Note: Refer to Operation and Maintenance Manual, "Fan and Alternator Belts" for the correct adjustment procedure.
Caterpillar Information System:
2000/09/04 Pilot Valves Now Have Serviceable O-Rings and Seals {4342}
2000/09/04 Additional Plugs for the Collets Are Now Available {4303, 5305, 6107, 7000}
CP-663E, CS-663E and CS-683E Vibratory Compactors Battery Disconnect Switch
Caterpillar Monitoring System MID 030 - CID 0428 - FMI 08
527 Track-Type Skidder Engine Supplement Muffler and Exhaust Extension - Remove and Install
3512 and 3516 EUI Engines for Caterpillar Built Machines Electronic Circuits
IT62G Series II Integrated Toolcarrier Diagnostic Codes (Caterpillar Monitoring System)
527 Track-Type Skidder Engine Supplement Hood - Remove and Install
Caterpillar Monitoring System MID 030 - CID 0427 - FMI 08
527 Track-Type Skidder Engine Supplement Air Cleaner - Remove and Install
725 and 730 Articulated Trucks Rollover Protective Structure (ROPS) - Inspect
C-9 Engines for Caterpillar Built Machines Cylinder Block Cover Group
IT62G Series II Integrated Toolcarrier Indicators
Caterpillar Monitoring System MID 030 - CID 0826 - FMI 08
2000/09/04 A Special Instruction Is Available for Installing New Wiring Harnesses on Harvester Heads {5734}
TH62, TH63, TH82 and TH83 Telehandlers Steering System Piston Pump (Implement and Steering)
725 and 730 Articulated Trucks Window Washer Reservoir - Fill
Caterpillar Monitoring System Quad Gauge Module
C-10, C-12, C-15 and C-16 Industrial Engines Diagnostic Codes
527 Track-Type Skidder Engine Supplement Turbocharger - Remove and Install
2000/09/25 The Piston Pump (Propel) and the Piston Pump (Vibratory) have Changed {5070}
2001/01/08 Replacement of Support Blocks for the Rear Axle and the Center Axle A-Frames Covered in Special Instruction, REHS0931 {3278, 7051}
C-9 Engines for Caterpillar Built Machines Electric Starting Motor
416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Axles, Differential and Brakes Axle, Differential and Brake Troubleshooting