Battery or Battery Cable - Inspect/Replace
- Turn the engine start switch to the OFF position. Turn all switches to the OFF position.
- Turn the battery disconnect switch to the OFF position. Remove the battery disconnect switch key.
- At the battery disconnect switch, disconnect the negative battery cable that is connected to the frame.
Note: Do not allow the disconnected battery cables to contact the disconnect switch. Do not allow the disconnected battery cables to contact the other cables. Do not allow the disconnected battery cables to contact the opposite terminal of either battery.
- Disconnect the negative battery cable at the battery.
- Disconnect the battery cable from the first battery.
- Remove the negative battery cable from the second battery. This will allow you to remove the cable.
- Remove the + battery cable from the second battery. In order to remove the cable that connects the two batteries, you must remove two clamps. The two clamps are located under the radiator at the rear of the machine.
- Remove the cable from the starter.
- Perform the necessary repairs. Replace the cables or the batteries, as needed.
- Reverse the above steps in order to reconnect the batteries.
- Connect the battery cable at the battery disconnect switch.
- Install the battery disconnect switch key. Turn the battery disconnect switch to the ON position.
- Install the battery compartment covers.
Caterpillar Information System:
CB-535B Vibratory Compactor Backup Alarm - Test
CB-535B Vibratory Compactor Backup Alarm
12H, 140H, 143H, 160H and 163H Motor Graders Hydraulic and Steering System Relief Valve (Implement)
924G and 924GZ Wheel Loaders Machine Systems Brake Accumulator - Remove and Install
2000/01/17 New Engine Software Improves Combustion During Extended Low Idle Periods {1901, 7620}
814F Series 2 Wheel Dozer, 815F Series 2 Soil Compactor and 816F Series 2 Landfill Compactor Tire Inflation - Check
CB-535B Vibratory Compactor Alternate Exit
CB-535B Vibratory Compactor Alert Indicators
824G Wheel Tractor, 825G Soil Compactor and 826G Landfill Compactor Hydraulic System Lift Cylinder - Isolation and Drift Check
924G and 924GZ Wheel Loaders Machine Systems Heater Coil - Remove and Install
784C and 785C Off-Highway Truck/Tractors Cooling System Relief Valve - Clean
CP-433C, CS-431C and CS-433C Paving Compactors Indicators and Gauges - Test
554 Forwarder and 574 Forwarder Tire Inflation - Check
CB-535B Vibratory Compactor Cab Air Filter - Clean/Replace
CB-535B Vibratory Compactor Reference Material
CB-535B Vibratory Compactor Changing Engine Speed
CB-535B Vibratory Compactor Changing Speed and Direction
539 Knuckleboom Loader Sound Information and Vibration Information
CB-535B Vibratory Compactor Circuit Breakers - Reset
CB-535B Vibratory Compactor Cooling System Coolant (DEAC) - Change
924G and 924GZ Wheel Loaders Machine Systems Ride Control Accumulator - Remove and Install
2000/02/07 The In-line Refrigerant Dryer Is Improved And A New Dryer For Service Replacement Is Available {7320, 7322}
2000/01/03 New Fan Drive Group Includes Serviceable Magnet And Pinned Bearing Races {1359}
D350E Series II, D400E Series II and D400E Series II Ejector Articulated Trucks Braking System General Information