Flywheel
Usage:
Typical Example
(1) Ring gear.
(2) Flywheel.
(3) Pilot bearing bore.
Install ring gear (1) on flywheel so that the chamber side (4) of ring gear (1) is as shown.
NOTE: Do not heat ring gear to more than 320°C (608°F) before installing on the flywheel.
Tighten flywheel bolts to a torque of ... 215 ± 40 N·m (160 ± 30 lb ft)
Caterpillar Information System:
3306C DIESEL TRUCK ENGINE Trunnion
3306C DIESEL TRUCK ENGINE Crankshaft Hub And Damper
3306C DIESEL TRUCK ENGINE Timing Gear Cover
3306C DIESEL TRUCK ENGINE Connecting Rod And Main Bearings
3306C DIESEL TRUCK ENGINE Bearing Surface (Journal) For Connecting Rods
3306C DIESEL TRUCK ENGINE Bearing Surface (Journal) For Main Bearings
3306C DIESEL TRUCK ENGINE Crankshaft
3306C DIESEL TRUCK ENGINE V-Belt Tension Chart
3306C DIESEL TRUCK ENGINE Piston And Rings
3306C DIESEL TRUCK ENGINE Connecting Rod
3306C DIESEL TRUCK ENGINE Cylinder Liner Projection
3306C DIESEL TRUCK ENGINE Cylinder Liner
3306C DIESEL TRUCK ENGINE Rear Gear Group (PTO)
3306C DIESEL TRUCK ENGINE Flywheel Housing
3306C DIESEL TRUCK ENGINE Flywheel Runout
3306C DIESEL TRUCK ENGINE Flywheel Housing Runout Face Runout (axial eccentricity) of the Flywheel Housing:
3306C DIESEL TRUCK ENGINE Flywheel Housing Bore
3306C DIESEL TRUCK ENGINE Alternators And Regulators 9L5938 12V 65A
3306C DIESEL TRUCK ENGINE Electric Starting Motors
3306C DIESEL TRUCK ENGINE Starter Solenoids
3306C DIESEL TRUCK ENGINE Shutoff Solenoids
3306C DIESEL TRUCK ENGINE Systems Operation
3306C DIESEL TRUCK ENGINE Testing And Adjusting
3306C DIESEL TRUCK ENGINE Introduction