Start By:
- Remove the engine oil cooler. Refer to Disassembly and Assembly, "Engine Oil Cooler - Remove".
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Separate oil cooler bonnet (1) and elbow (3) from oil cooler (2).
Show/hide table
Illustration 2 g00619616 - Remove O-ring seal (4) from oil cooler bonnet (1).
Show/hide table
Illustration 3 g00619807 - Remove adapter (5) from elbow (3). Remove O-ring seals (6) from adapter (5).
Show/hide table
Illustration 4 g00619745 - Clean tubes (7) for the oil cooler core with a
3.81 mm (0.150 inch) rod.
Illustration 1 | g00619597 |
Note: Put identification marks on the oil cooler, the oil cooler bonnet, and the elbow for the oil cooler for proper alignment during assembly.