Removal Procedure
Start By:
- Remove the hydraulic implement and the steering pump. Refer to Disassembly and Assembly, SENR6776, " Remove and Install Hydraulic Implement and Steering Pump".
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines. Dispose of all fluids according to local regulations and mandates. |
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, all hoses and all tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
- Disconnect connector (1) .
Illustration 1 | g00488542 |
- Remove hose assemblies (2) and (3) .
Illustration 2 | g00488544 |
- Remove four bolts and washers (4). Remove two coupling (5). Reposition line (6) to the side.
Illustration 3 | g00490169 |
- Disconnect lines (7) and (8) .
- Remove four bolts and washers (9). Remove two coupling (10). Reposition line (11) to the side.
Illustration 4 | g00488740 |
- Remove tube assembly (12) .
- Support the piston pump with a suitable lifting device. Remove two bolts (13). Remove the piston pump from the engine. The weight of the hydrostatic piston pump is 66 kg (146 lb).
Illustration 5 | g00488760 |