Usage:
start by:
a) remove fuel injection pump housing and governor
NOTICE |
---|
Thoroughly clean the outside of the fuel injection pump housing before the fuel pumps are removed. |
1. Put the pump housing in position on tool (A). Remove cover (1) from the pump housing.
2. Loosen the bushing from the pump housing with tool (B).
NOTE: Do not loosen screws (2). If the screws are loosened, the fuel pump adjustment will be changed.
3. Remove the fuel injection pump from the housing. The sleeve on the plunger will slide off the lever as the pump is removed.
NOTE: Keep the plunger and sleeve with their respective barrel for installation. Do not use plunger, sleeves or barrels with other plungers, sleeves or barrels.
Install Fuel Injection Pumps
NOTICE |
---|
Make sure the sleeve is installed with the thin edge up. |
1. Put the fuel injection pump in the bore in the pump housing so sleeve (1) is engaged with lever (2).
NOTICE |
---|
If the screws in the levers have been loosened, an adjustment must be made for the fuel pumps. See FUEL PUMP CALIBRATION as shown in TESTING AND ADJUSTING. |
2. Tighten the bushing for the fuel pump with wrench (B) to a torque of 70 ± 5 lb.ft. (95 ± 7 N·m).
3. Install cover (3) and make sure the spring is in the correct position in the cover.
4. Remove pump housing from tool (A).
end by:
a) install fuel injection pump housing and governor