Crankshaft Front Seal
Usage:
Remove Crankshaft Front Seal
start by:
a) remove crankshaft pulley
1. Remove the front seal with tool group (A).
Install Crankshaft Front Seal
1. Put 7F2770 Cement on the outer metal surface of the front seal. Put the seal in position on the short end of the installer assembly (A). The lip of the seal must be toward the inside of the engine.
NOTE: If a new wear surface for the front seal is needed, put the spacer from tooling (A) between the seal and flange of the installer assembly.
2. Put the seal and installer assembly in position on the end of the crankshaft. Install bolt (1) and washer (2) that hold the crankshaft pulley in place. Tighten the bolt until the installer assembly makes contact with the crankcase gear. Remove the bolt, washer and tool (A).
end by:
a) install crankshaft pulley
Caterpillar Information System:
3208 TRUCK ENGINE Crankshaft Pulley
3208 TRUCK ENGINE Valve Lifters
3208 TRUCK ENGINE Pistons
3208 TRUCK ENGINE Cylinder Heads
3208 TRUCK ENGINE Fuel Injection Nozzles
3208 TRUCK ENGINE Rocker Shafts
3208 TRUCK ENGINE Rocker Shafts And Push Rods
3208 TRUCK ENGINE Crankcase Ventilator Valve
3208 TRUCK ENGINE Valve Covers
3208 TRUCK ENGINE Water Pump
3208 TRUCK ENGINE Water Temperature Regulators
3208 TRUCK ENGINE Connecting Rod Bearings
3208 TRUCK ENGINE Timing Gear Cover And Oil Pump
3208 TRUCK ENGINE Oil Pump And Relief Valve
3208 TRUCK ENGINE Camshaft And Gears
3208 TRUCK ENGINE Automatic Timing Advance
3208 TRUCK ENGINE Flywheel
3208 TRUCK ENGINE CRANKSHAFT REAR SEAL AND WEAR SLEEVE
3208 TRUCK ENGINE Flywheel Housing
3208 TRUCK ENGINE Crankshaft And Gear
3208 TRUCK ENGINE Camshaft Bearings
3208 TRUCK ENGINE General Information
3208 TRUCK ENGINE Basic Block
3208 TRUCK ENGINE Cylinder Head And Valve Components