Crankcase Breather
Usage:
Remove And Install Crankcase Breather
1. Loosen clamps (2) on tube and slide hose on to tube. Remove bolt (1) from crankcase breather. Remove crankcase breather (3). Remove O-ring seal from crankcase breather.
2. Install a new O-ring seal on the crankcase breather.
3. Install the crankcase breather on the valve cover with bolt (1). Tighten the bolt to a torque of 10 ± 2 lb.ft. (14 ± 3 N·m).
4. Slide the hose on to the crankcase breather (3) and tighten clamps (2).
Caterpillar Information System:
3208 TRUCK ENGINE Air Inlet Manifold
3208 TRUCK ENGINE Actuator
3208 TRUCK ENGINE Remove Actuator And EGR Valve
3208 TRUCK ENGINE EGR Switch Assembly
3208 TRUCK ENGINE Fuel Setting
3208 TRUCK ENGINE Automatic Timing Advance Unit 3° For EGR Engine
3208 TRUCK ENGINE EGR Actuator And EGR Valve
3208 TRUCK ENGINE EGR Valve
3208 TRUCK ENGINE EGR Actuator
3208 TRUCK ENGINE EGR Tube
3208 TRUCK ENGINE Breather
3208 TRUCK ENGINE Air Inlet Manifold
D353 INDUSTRIAL & MARINE ENGINES Introduction
D353 INDUSTRIAL & MARINE ENGINES Fuel Injection Equipment
D353 INDUSTRIAL & MARINE ENGINES Fuel Transfer Pump
D353 INDUSTRIAL & MARINE ENGINES Fuel Pump And Governor Drive
D353 INDUSTRIAL & MARINE ENGINES Fuel Filter
D353 INDUSTRIAL & MARINE ENGINES Camshaft And Timing Gears
D353 INDUSTRIAL & MARINE ENGINES Accessory Drive Group
D353 INDUSTRIAL & MARINE ENGINES Gear Group (Camshaft Idler and Power Take-Off Idler)
D353 INDUSTRIAL & MARINE ENGINES Governor (Earlier)
D353 INDUSTRIAL & MARINE ENGINES Service Meter
D353 INDUSTRIAL & MARINE ENGINES Governor (Later)
D353 INDUSTRIAL & MARINE ENGINES Primary Fuel Filter