Rocker Shafts And Push Rods
Usage:
Remove Rocker Shafts And Push Rods
start by:
a) remove valve covers
1. Remove bolts (2) from rocker shaft (3) and remove rocker shaft. Remove push rods (1).
Install Rocker Shafts And Push Rods
1. Install push rods (2). Put rocker shaft (1) in position on the engine. Install the bolts that hold the rocker shaft in position. Tighten the bolts to a torque of 18 ± 5 lb. ft. (24.4 ± 6.8 N·m).
2. Make adjustment until the intake valve clearance is .015 in. (0.38 mm) and the exhaust valve clearance is .025 in. (0.64 mm). Tighten nuts (3) to a torque of 24 ± 5 lb. ft. (32.5 ± 6.8 N·m).
end by:
a) install valve covers
Caterpillar Information System:
3208 TRUCK ENGINE Crankcase Ventilator Valve
3208 TRUCK ENGINE Valve Covers
3208 TRUCK ENGINE Water Temperature Regulators
3208 TRUCK ENGINE Water Pump
3208 TRUCK ENGINE Connecting Rod Bearings
3208 TRUCK ENGINE Crankshaft Main Bearings
3208 TRUCK ENGINE Oil Pan
3208 TRUCK ENGINE Fuel Filter Base
3208 TRUCK ENGINE Oil Filter Base And Engine Oil Cooler
3208 TRUCK ENGINE Starter
3208 TRUCK ENGINE Exhaust Manifold
3208 TRUCK ENGINE Fuel Injection Pump Housing
3208 TRUCK ENGINE Rocker Shafts
3208 TRUCK ENGINE Fuel Injection Nozzles
3208 TRUCK ENGINE Cylinder Heads
3208 TRUCK ENGINE Valve Lifters
3208 TRUCK ENGINE Pistons
3208 TRUCK ENGINE Crankshaft Pulley
3208 TRUCK ENGINE Crankshaft Front Seal
3208 TRUCK ENGINE Timing Gear Cover And Oil Pump
3208 TRUCK ENGINE Oil Pump And Relief Valve
3208 TRUCK ENGINE Camshaft And Gears
3208 TRUCK ENGINE Automatic Timing Advance
3208 TRUCK ENGINE Flywheel