NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Do not disconnect the air lines until the air pressure in the system is at zero. If hose is disconnected under pressure it can cause personal injury. |
- Loosen the purge valves, and release the air pressure in the air tank.
Show/hide table
Illustration 1 g00620850 Typical example - Disconnect coolant supply line (1) and air supply line (2) from the air compressor.
- Disconnect oil supply line (3) from the air compressor.
Show/hide table
Illustration 2 g00620840 Typical example - Remove coolant line (4) from the air compressor.
- Remove nuts (5) that hold the air compressor to the accessory drive.
- Remove the air compressor from the engine.
Show/hide table
Illustration 3 g00620856 Typical example - Remove seal (6) from the air compressor.
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install new seal (6) on the air compressor.
- Install the air compressor on the engine.
Show/hide table
Illustration 5 g00620840 Typical example - Install nuts (5) to hold the air compressor on the engine.
- Connect coolant line (4) to the air compressor.
Show/hide table
Illustration 6 g00620850 Typical example - Connect coolant supply line (1) to the air compressor.
- Connect air supply line (2) to the air compressor.
Show/hide table
NOTICE To prevent water from collecting and freezing in the air compressor lines, ensure that the air compressor lines are sloping downward and away from the air compressor.
- Connect oil line (3) to the air compressor.
Illustration 4 | g00620856 |
Typical example |