Start By:
- Remove the fan.
- Remove the refrigerant condenser and mounting.
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
Personal injury can result from hot coolant, steam and alkali. At operating temperature, engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot coolant or steam. Any contact can cause severe burns. Remove cooling system pressure cap slowly to relieve pressure only when engine is stopped and cooling system pressure cap is cool enough to touch with your bare hand. Do not attempt to tighten hose connections when the coolant is hot, the hose can come off causing burns. Cooling System Coolant Additive contains alkali. Avoid contact with skin and eyes. |
- Drain the hydraulic oil into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change" for the correct draining and filling procedures.
- Drain the coolant into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct draining and filling procedures.
Show/hide table
Illustration 1 g06307179 - Disconnect hose (1).
- Remove bolts (3) and reserve tank assembly (2).
Show/hide table
Illustration 2 g06307180 - Remove bolts (5) and support assembly (4).
Show/hide table
Illustration 3 g06307181 - Attach a suitable lifting device to remove door (6). The weight of door (6) is approximately
20 kg (44 lb) . - Remove bolts (7) and door (6).
Show/hide table
Illustration 4 g06307183 - Remove bolts (9) and cover (8).
Show/hide table
Illustration 5 g06307184 - Loosen the clamps and disconnect hose (10).
- Loosen the clamps and disconnect hose (11).
Show/hide table
Illustration 6 g06307185 - Loosen the clamps and disconnect hose (12).
Show/hide table
Illustration 7 g06307187 - Attach a suitable lifting device to remove cooling system package (13). The weight of cooling system package (13) is approximately
125 kg (276 lb) .Show/hide tableIllustration 8 g06307188 - Remove two bolts (14), two bolts (16), and bracket (15).
Show/hide table
Illustration 9 g06307189 - Remove bolts (18) and cover (17).
Show/hide table
Illustration 10 g06307190 Show/hide tableIllustration 11 g06307191 - Remove bolts (19).
Show/hide table
Illustration 12 g06307209 - Remove bolts (20).
Show/hide table
Illustration 13 g06307192 Show/hide tableIllustration 14 g06307193 - Remove bolts (21) and cooling system package (13).
- Install cooling system package (13) in the reverse order of removal.