1984/12/12 Caterpillar


A Soot Filter Is Available For Use With Air Cleaners

Usage:


3406, 3406B, 3408, 3408B, 3412, D379, G379, D398, G398, D399, G399 Marine, Industrial And Generator Set Engines

A soot filter is available for use with the above engines. The soot filter acts as a precleaner and extends the service life of the primary air filter.

A soot filter is recommended in severe applications when short air filter life is experienced. Make reference to this article in the appropriate parts books.

Soot filters are recommended for use as shown in the chart.

Caterpillar Information System:

1984/12/12 New Pressure Gauges Have Dual Scales [kPa (psi)]
1984/12/12 Causes And Correction Of Opposite Crankshaft Rotation In Direct Injection Engines
1984/12/12 Additional Information For Correct Fuel Injector Timing
1984/10/24 New Cylinder Head Gasket Helps Prevent Oil Leakage Around Gear Pocket
1984/10/24 Wiring Changed On Voltage Regulators
1984/10/24 Deflection Of Flywheel Housings Should Be Controlled During Transportation
1984/10/24 New Heat Shield For Wiring To Electrical Shutoff Group
1984/10/24 New Heat Exchanger Group Has More Cooling Capacity
1984/10/24 Changes To Water Lines Group Increase Coolant Flow Through Exhaust Manifold
1984/10/24 New Indicator Lamps Used On Generator Control Panels
1984/10/24 New Gaskets Give A Better Seal To Watercooled Exhaust Manifolds
1984/10/24 Helper Spring Groups Improve Operation Of Air Shutoff Groups
1984/12/12 Improved Turbocharger Oil Drain Elbows
1984/12/12 Remanufactured Turbocharger Groups
1984/12/12 Thread Identification Kit Available
1984/12/12 Starters That Remain Engaged After Engine Is Running
1984/12/12 New 76.6°C (170°F) Water Temperature Regulators Used In Inlet Controlled Cooling Systems
1984/12/12 Additional Clamp Reduces Vibration Of Turbocharger Oil Supply Line
1984/12/12 Addition Of Lubricator Will Help Prevent Corrosion In Air Prelube Motors
1984/12/12 Preferred Engine Timing Procedures
1984/12/12 Identification Of Camshaft Groups And Valve Mechanism Groups
1984/12/12 New Seal Used In Alternator Mounting Group
1984/12/12 Rear Power Take-Off Clutch Can use Nonmetallic Plates And Grease Lubrication For Main Bearings
1984/12/12 Important Differences In Engine Arrangements On 3208 Engines Equipped With Turbochargers
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.